Tabla de contenido
)
@
=
*
A
B
8
?
>
C
D
E
Power Supply
Preparations
Using the AC adaptor
Connect the AC adaptor supplied.
a DC IN jack (DC IN 4.5 V
b Right side panel of the unit
c AC adaptor
d AC power outlet
Note:
The unit is in the standby condition when the AC adaptor
is connected. The primary circuit is always "live" as long
as the AC adaptor is connected to an AC power outlet.
Using dry-cell batteries
(not included)
After disconnecting the AC adaptor, insert two "R6" (LR-
6) alkaline batteries.
The procedure for inserting and removing dry-cell bat-
teries is identical to that for rechargeable batteries.
Battery indicator
e Battery indicator
The battery indicator changes as shows on the left ac-
cording to the remaining capacity of the battery.
f Fully charged
g Low battery
h Empty
i After a while the unit will turn off
Rechargeable batteries: Recharge batteries.
Dry-cell batteries: Replace batteries with new ones.
Notes:
• The length of time the unit can continue further opera-
tion after the battery indicator changes to "
depending on the type of batteries used.
• The battery indicator may not be correctly displayed if
rechargeable batteries, other than those designated by
JVC, are used.
• When power is supplied from the AC adaptor, "
dicator always lights up.
Tip:
Turning off the Anti-Shock Protection (see page 24) will
save the battery power more or less.
If the unit malfunctions or freezes during use,
disconnect the power source (the AC adaptor
and batteries) once. Then, connect the power
source and operate the unit again.
)
" differs
" in-
Tabla de contenido
Solución de problemas
