Dust Collection - Evolution EB225DWSHH Manual De Instrucciones

• Keep the Sander in constant motion
whilst the abrasive disc is in contact with
the work surface. Use a steady, sweeping
motion, allowing the rotating abrasive disc
to 'float' over the work surface. Moving
the Sander erratically or concentrating
for too long on one area can cause swirl
marks or unevenness in the work surface.
Caution: Always keep your hands away
from the Sanding Head. The Sanding Head
swivels in multiple directions and could
pinch your hands.
WARNING: Do not allow the rotating
abrasive disc to contact sharp objects such
as protruding nails, screws etc, or wall
architecture such as electrical boxes or
switch plates. Damage to the Sander or the
wall fittings could result.

Dust Collection

Dust collection is automatic. Wall dust will
sucked from the Sanding Head, along the
dust extraction hose and deposited in the
Dust Collection Bag.
Note: We recommend for operational
efficiency that the Dust Collection Bag is
emptied when it is approximately 2/3 full.
Emptying the Dust Collection Bag
WARNING: Only empty the Dust Collection
Bag when the machine is switched 'Off'.
The Dust Collection Bag has an open seam
which is sealed by a plastic slide fastener.
(Fig. 10)
Fig. 10
HAND HELD DRYWALL SANDER
Slide this fastener from the Dust Collection
Bag to open the seam.
Dispose of the contents of the Dust
Collection Bag in an environmentally
responsible way.
Note: It may be necessary for the
operator to wear a dust mask and other
PPE (Personal Protection Equipment) as
necessary when disposing of the contents
of the Dust Bag.
Reseal the seam by sliding the plastic
fastener back onto the Dust Collection Bag.
MAINTENANCE
MAINTENANCE
Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains/battery
power supply. Check that all safety features
and guards are operating correctly on a
regular basis. Only use this machine if all
guards/safety features are fully operational.
All power bearings in this machine are lubricated
for life. No further lubrication is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings in
the machines casings etc. The machines air
vents should be cleaned using compressed
dry air.
Excessive sparking may indicate the
presence of dirt in the power or worn out
carbon brushes.
UK
15