Memory Storage Of Radio Controls Coding; Memory Storage Of Radio Controls; Remote Memory Storage Of - Genius ZODIAC 60 Manual Del Usuario

12 MEMORY STORAGE OF RADIO CONTROLS CODING

The control unit has an integrated 2-channel decoding system.
This system makes it possible to memory-store both total ope-
ning (OPEN A) and partial opening (OPEN B) of the automated
system - this is made possible by an additional receiver module
(Fig. 30 ref. ) and radio controls on the same frequency.


12.1 Memory storage of radio controls 868

A Maximum of 250 codes can be memory stored, split
between OPEN A and OPEN B.
1) On the radio control, simultaneously press and hold down
push-buttons P1 and P2.
2) The radio control LED begins to flash.
3) Release both push-buttons.
4) To respectively memory store total or partial opening, press
the OPEN A or OPEN B push-button for one second (Fig. 31
ref. ).
5) The relevant LED starts to flash slowly for 5 sec.
6) Within these 5 sec., while the radio control LED is still flashing,
press and hold down the required push-button on the radio
control (the radio control LED lights up on steady beam).
7) The LED on the board lights up on steady beam for 1 second
and then goes OFF, indicating that storage was executed.
8) Release the radio control push-button.
9) Quickly press twice in succession the memory stored radio
control push-button.
The automated system performs one opening operation.
Make sure that the automated system is free of any
obstacle created by persons or things.
10) To add other radio controls, transfer the code of the
memory-stored push-button of the radio control to the
relevant push-button of the radio controls to be added,
observing the following procedure:
- On the memory stored radio control, simultaneously press and
hold down push-buttons P1 and P2.
- The radio control LED begins to flash.
- Release both push-buttons.
- Press and hold down the memory-stored push-button (the radio
control LED lights up on steady beam).
- Approach the radio controls to each other and hold down the
push-button corresponding to the radio control to be added;
then release it after a double flash of the radio control LED
indicating that storage was executed.
Fig. 30
- Quickly press twice in succession the memory stored radio
control push-button
The automated system performs one opening operation.
Make sure that the automated system is free of any
obstacle created by persons or things.
12.2 Memory storage of radio controls 433
A Maximum of 250 codes can be memory stored, split
between OPEN A and OPEN B.
1) Use 433 remote controls only with receiver module at 433
MHz.
2) To respectively memory store total or partial opening, press
the OPEN A or OPEN B push-button for one second (Fig. 31
ref. ).
3) The relevant LED starts to flash slowly for 5 sec.
4) Within these 5 secs., press the appropriate push-button on
the 433 remote control.
5) The LED lights up on steady beam for 1 second, indicating
memory storage executed, and then resumes flashing for
another 5 sec., during which another radio control (point 4)
can be memory stored.
6) When the 5 secs. have elapsed, the LED goes OFF indicating
the end of the procedure.
7) To add other radio controls, repeat the operation from point
1).
12.2.1 Remote memory storage of 433 radio controls

Other radio controls can be remotely stored only with the 433
radio controls, i.e. without using the RADIO SETUP
push-buttons, but using a previously stored radio control.

1) Obtain a radio control already stored on one of the 2
channels (OPEN A or OPEN B).
2) Press and simultaneously hold down push-buttons P1 and P2
until the lights of both the LEDs on the board light up.
Fig. 31

.