Filling Oil Tank - Worx WG322 Manual De Instrucciones

ASSEMBLING THE EXTENSION POLE
(Only for WG323, WG323.9)
Align and insert the handle of extension
pole into the shaft. Rotate the locking knob
clockwise to lock. (SEE Fig. F1, F2)
NOTE: Make sure that the shaft is firmly
locked in place.
ASSEMBLING THE EXTENSION POLE TO
THE MACHINE (See Fig G1)
Step1: Align and insert the pole connection
bracket (29) into the saw.
Step2: Turn the Locking Knob (28)
counterclockwise to tighten the extension pole
to the machine.
NOTE: Make sure the extension pole
is locked into position securely before
operation.
REMOVING THE EXTENSION POLE (See
Fig. G2)
Step1: Turn the Locking Knob (28) clockwise to
loosen and pull it out.
Step2: Slide saw to disconnect the extension
pole with the saw.
WARNING!
• When using this machine with the
18
Extension Pole, make sure that the
battery pack has been removed.
Adjusting pole length
The pole saw has a telescoping pole assembly
that will extend from 77 inches (fully retracted)
to 105 inches (fully extended).
Clamping level (26) is used to hold the pole in
position at any extended length.
1. To extend the pole, loosen the clamping
lever as shown in Fig H. Pole will slide
freely.
2. Pull inner pole section out to desired length
of extension. Note: only extend pole to
minimum length required to reach limb
that is being cut.
3. To lock pole in position, tighten clamping
lever as shown in Fig. H.
LUBRICATION
IMPORTANT: The chain saw is not
filled with oil. It is essential to fill
with oil before use. Never operate the
20V cordless chain saw, 20V 2-in-1 pole saw/
chain saw (WG322 WG322.9 WG323 WG323.9)
chain saw without chain oil or at an
empty oil tank level, as this will result in
extensive damage to the product.
NOTE: Chain life and cutting capacity
depend on optimum lubrication.
Therefore, the chain is automatically
oiled during operation.

FILLING OIL TANK:

WARNING: Removing the battery
pack before filling the oil tank.
1. Set chain saw on any suitable surface with
Oil Filler Cap (3) facing upward.
2. Clean area around the Oil Filler Cap with
cloth and unscrew the cap by turning it
counter clockwise.
3. Add bar and chain oil until tank is full.
4. Avoid dirt or debris entering oil tank, refit
Oil Filler Cap (3) and tighten by turning
clockwise until hand tight.
IMPORTANT: To allow venting
of the oil tank, small breather
channels are provided between the Oil
Filler Cap and the strainer, to prevent
leakage, and ensure machine is left in
a horizontal position (Oil Filler Cap (6)
uppermost) when not in use.
It is important to use only the
recommended standard bar and chain oil
(Grade: ISO VG32) to avoid damage to
the chain saw. This can be found at the
location where you purchased this saw
or your local hardware store. Never use
recycled/old oil. Use of non approved oil
will void the warranty.
Do not swallow. If swallowed, call a
physician immediately. Keep out of reach
of children. Store away from heat or
open flame.
CHECKING THE AUTOMATIC OILER
Proper functioning of the automatic oiler
can be checked by running the chain saw
and pointing the tip of the Guide chain bar
(6) towards a piece of cardboard or paper
on the ground. If an increasing oil pattern
develops on the cardboard, the automatic
oiler is operating fine. If there is no oil pattern,
despite a full oil reservoir, contact WORX
customer service agent or WORX approved
service agent.
EN