Entering Dimensions In The Motorcycle Programmes; Wheel Spin - SICE S 62 E Manual De Instrucciones

PLAN DETECTION BY LASERX POINTER
(IF PRESENTED)
Geometry data detection for real balancing plans for the ap-
plication of adhesive weights can be facilitated by the laser
line on the automatic detector lever.
To enable this line, it is necessary to press the button on the
automatic arm (A, Fig.15b).
The laser line remains visible inside the rim for 10 seconds,
then, if necessary, press the button on the automatic arm again.
15b
5. ENTERING DIMENSIONS
IN THE MOTORCYCLE
PROGRAMMES
The operations described below are valid if the
motorcycle setting (byke) has been activated in the
"vehicle type" set up.
- Fit the appropriate extension on the inner measur-
ing arm, specifically extension A on machines with
no weight holder or extension B on machines with
weight holder (Fig.16).
16
- To acquire the wheel dimensions, follow the instruc-
tions in the paragraph "Entering wheel dimensions".

6. WHEEL SPIN

Wheel spins take place by pressing the key.
WARNING
To obtain the most accurate results, we recommend not improperly solicit the wheel bal-
ancer during the spin.
CAUTION
If the wheel keeps spinning permanently due to a fault on the machine, switch off the machine
using the main switch or disconnect the plug from the power supply board (emergency stop).
If the key is pressed whilst the wheel is rotating, the spin will be prematurely inter-
rupted.
S 62 E Operator's manual 93