Sears CRAFTSMAN 536.886261 Manual Del Usuario página 9

TO INSTALL SHIFTER KNOB
1. Thread the shifter lever knob onto
the threaded end of the shifter le-
ver until it is snug against the hex
jam nut and the lip is pointed away
from the engine. Tighten the hex
jam nut against the bottom of the
shifter lever knob to lock in posi-
tion.
NOTE: If the cables have become dis-
connected, connect cables as shown in
Figure 8.
Traction Drive Cable Auger Drive Cable
SNOW CHUTEASSEMBLY
1. Turn crank assembly counterclock-
wise until it stops.
2. Position snow chute on inside of
snow chute flange and align the
three holes in the snow chute with
holes on snow chute flange. (See
Figure 9)
3. Place three 5/16-18 carriage bolts
from inside of chute as shown in
Figure 9. (hardware is found in
parts bag).
4. Place three 5/16-18 flatwashers
and three 5/16-18 nuts on outside
of flange.
5. Tighten all four carriage bolts se-
curely.
NOTE: DO NOT overtighten carriage
bolts.
Figure 8
6. Turn crank assembly clockwise and
make sure all carriage bolts are
tight.
Carriage
Bolts ,
Snow Chute
Nut
/
Flange
Figure 9
F-011050L 9