Use - SATA jet X 5500 Instrucciones De Servicio

Operating Manual SATAjet X 5500 RP/HVLP (DIGITAL)
EN
6.4.2 Additional notes concerning the electronic
pressure gauge
The electronic pressure measurement system has been type-tested. It is
developed, designed and produced in compliance with the EU Directive
2014/34/EU. It has been classified according to Ex ia IICT4 Ga or Ex ia
IICT4 Gb. It may be used and stored in ex-zone 1 and 2 up to 60°C ambi-
ent temperature. Inspection body: KEMA 05 ATEX 1090 X. Other approv-
als: FM Global IS CL I DIV 1 GPS ABCD T4 Ta = 60°C, IS CL I DIV 1 ZN
0 AEx ia IIC T4 Ta = 60°C
and CSA IS CLI I DIV 1, GP A, B, C, D T4, Ex ia IIC T4 Gb, CL I ZN 1
AEx ia IIC T4 Gb Tamax = 60°C, CSA_05CA1692762.
The following applications and actions will lead to the loss of
explosion protection and any warranty claims and are there-
fore prohibited:
• Battery exchange in explosive areas!
• Removal of the front cover of the pressure display!
• Installation of a battery other than the CR 1632 Renata!
When exchanging the battery, it is recommended to also replace the
sealing of the battery compartment!
7.

Use

• Use only solvent-resistant, antistatic, undamaged and technically
flawless compressed air hoses with a permanent pressure resistance
of minimum 10 bar, e.g. Art. No. 53090!
The following requirements must be fulfilled:
• Compressed air connection 1/4" male thread or a suitable SATA con-
nection nipple.
• Ensure minimum compressed air volume (air consumption) and pres-
sure (recommended spray gun inlet pressure) according to chapter 2.
118
Warning! Risk of explosion!
Warning! Risk of explosion!
Notice!