Ice Service - Kenmore 253.6000 Serie Manual De Uso Y Cuidado

Ice Service

If your refrigerator has an automatic ice
maker, it will provide a sufficient supply
of ice for normal use. During the initial
startup of your refrigerator, however, no
ice will be produced during the first 24
hours of operation. Air in new plumbing
lines may cause the ice maker to cycle
two or three times before making a full
tray of ice. With no usage, it will take
approximately one to two days to fill the
ice container.
New plumbing connections may cause
the first production of ice cubes to be
discolored or have an odd flavor. Discard
ice made during the first 24 hours.
NOTE
Automatic ice makers are also optional
accessories that may be installed in
most models at any time.
Call 1-844-553-6667 for information.
Turning your ice maker on
After the plumbing connections have been
completed, the water supply valve must
be opened. Place the ice container under
the ice maker, pushing it as far back as
possible. Lower the wire signal arm to its
"down" or ON position.
Turning your ice maker off
To stop the
ice maker,
lift the
wire signal
arm until
it clicks
and locks
in the "up"
or OFF
position.
The ice
maker
also turns off automatically when the ice
container is full. If your model has an
adjustable freezer shelf, place the shelf in
the lower position, so that the wire signal
arm will hit the ice when the container is full.
IMPORTANT
Your ice maker is shipped from the factory
with the wire signal arm in the ON position.
To ensure proper function of your ice maker,
hook up water supply immediately or turn
ice maker OFF by lifting the wire signal arm
until it clicks and locks in the UP position.
If the ice maker is not turned off and the
water supply is not connected, the water
valve will make a loud chattering noise.
Ice Production: What To Expect
The ice maker will produce 2 to 3 pounds
of ice every 24 hours depending on usage
conditions. Ice is produced at a rate of 8
cubes every 75 to 160 minutes.
Chemicals from a malfunctioning
softener can damage the ice maker.
If the ice maker is connected to soft
water, ensure that the softener is
maintained and working properly.
Ice Maker Tips
• Ice cubes stored too long may develop
an odd flavor. Empty the ice container
and ensure that the wire signal arm is
in its "down" or ON position. The ice
maker will then produce more ice.
• Occasionally shake the ice container to
keep ice separated.
• Stop the ice maker when cleaning the
ON
freezer and during vacations.
• If the ice maker will be turned off for
a long period of time, turn the water
OFF
supply valve to a closed position.
NOTE
Wire
Signal Arm
For information on ice maker noises, see
Normal Operating Sounds section.
DO NOT place the ice container in your
dishwasher.
• Wash the ice container in warm water
with mild detergent. Rinse well and dry.
21
CAUTION
CAUTION