JVC KD-R890BT Manual De Instrucciones página 37

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (B) Trim plate
(C) Mounting sleeve (D) Wiring harness
(E) Extraction key
Basic procedure
1 Remove the key from the ignition switch, then disconnect
the terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 34)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the terminal of the car battery.
5 Press to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds.
( 3)
Installing the unit (in-dash mounting)
Orientate the trim plate as
illustrated before fitting.
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from the
unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Do the required wiring.
( 34)
Hook on the top side
Bend the appropriate tabs to
hold the sleeve firmly in place.
How to remove the unit
Dashboard of
your car
33
ENGLISH