Step 5: Remove Toe Kick; Step 6: Install 90° Elbow - LG LDS5040ST/00 Manual De Instrucciones

These installation instructions are intended for use by Qualified Installers.
NOTE
If at any time the dishwasher is laid on its back, take
care not to damage the drain hose.

STEP 5: REMOVE TOE KICK

y Remove the two screws attaching the lower cover to
the dishwasher.
y Remove the lower cover from the base.
y Remove the insulation pad from behind the access
panel.
STEP 6: INSTALL 90° ELBOW (Non L type valve only)
y When installing the 90° elbow into the inlet valve, Tef-
lon® tape should be used to avoid water leaks.
y Install a 90° elbow onto the water valve.
* When installing the elbow onto the dishwasher be
careful not to apply the wrench to the threads of the
elbow.
This will cause damage to the threads and the end re-
sult will be a leak.
* L type valve does not need this step.
FIG. 10-1
Non L Type Valve
INSTALLATION INSTRUCTIONS
FIG. 9
Mounting
screw
FIG. 10
Te on
tape
FIG. 10-2
L Type Valve
9
Toe kick
Elbow