en
19
Figure
Put the dust bag back into the vacuum
cleaner and close the dust bag compartment
lid.
!
Caution: The inside of the dust container
may become scratched with use and start
to look opaque. This does not, however,
affect the performance of the vacuum
cleaner in any way, i.e. it will continue to
function as normal.
Cleaning the permanent filters and
micro filters in the dust container
The filters must be cleaned:
After any operating malfunctions, i.e. after a
blockage is cleared.
At least every six months.
20
Figure
Press the fastener on the rear side of the
container and remove the micro filter from the
bottom of the container.
Remove the permanent filter from the bottom
plate of the container.
21
Figure
Wash the micro- and permanent filters.
The filter must then be left to dry for at least
24 hours.
After cleaning, place the permanent filter on
the bottom plate of the container.
Put the micro filter onto the container and fix
it in place by pushing in the direction of the
arrow. You will hear the flap snap shut.
Blockages
Removing a blockage in the dust container.
22
Figure
Empty the container (see figure 18)
Loosen the blockage, e.g. with a screwdriver,
and tap or vacuum it out.
(You must fit a dust bag in the vacuum
cleaner before vacuuming it out - see
Figure 23)
Close the bottom flap so that it can be heard
snapping into position.
!
Caution: The micro- and permanent filters
must be cleaned following any operating
problem (see Figure 20 and 21).
Using dust bags
If necessary, a dust bag may be used instead of
the dust collector.
Part number on the spare filter packaging:
VZ52AFG1
23
Figure
Open the vacuum cleaner lid (see Figure 16)
Remove the dust collector and insert a dust
bag.
Close the vacuum cleaner lid.
You have bought an extremely powerful device.
The highest suction setting is therefore only
recommended for heavily soiled, short-pile
carpets and hard floors.
The required suction power can be selected by
adjusting the suction regulator (see Figure 8).
Low suction range:
For vacuuming delicate fabrics, e.g. curtains.
Middle suction range:
For daily vacuuming of lightly soiled floors.
High suction range:
For vacuuming durable floor coverings, hard
floors and for heavily soiled surfaces.
11