Battery Charging - Clarke CA90 32T Instrucciones De Uso

BATTERY CHARGING

WARNING !
Use only approved chargers with the following specifi cations:

Automatic shut-off circuit

Deep cycle charging

Output current of 20-30 Amps.

Output voltage of 36 volts.
HINT: For the best machine performance, keep batteries charged at all times. Do not let them sit in a discharged condition.
WARNING !
Batteries are dangerous! Batteries emit hydrogen gas and an explosion or fi re can result. Keep sparks and fi re away from batteries at
all times. When charging the machine, make sure the battery compartment is left open.
1. Place charger and machine in a well-ventilated area.
2. Turn machine off.
3. Open recovery tank up, exposing battery compartment.
4. Check fl uid level in each battery cell. Do not charge batteries unless fl uid is slightly covering the battery plates. Do not overfi ll the batteries.
Overfi lling may cause the batteries to overfl ow during charging due to expansion. Replace the caps prior to charging.
5. Plug approved charger into grounded wall outlet before plugging the charger into the machine.
6. Plug charger into grey charger receptacle located in the front left of the battery compartment.
7. Flip up the recovery tank "kick stand" and gently lay the recovery tank down until it rests on the stand. 8. The charger will automatically begin to charge the batteries, and it will automatically shut down once the batteries are fully charged.
9. Upon completion of charging, fi rst unplug the charger from the wall outlet and then disconnect the charger from the machine.
10. Check the battery fl uid level after charging is completed. If the fl uid level is low, add distilled water to bring the fl uid level up to the bottom of
the sight tubes. Replace the caps and wipe the batteries down with a towel.
7/2014
INSTRUCTIONS FOR USE
56091127 - CA90 32T
ENGLISH - A
A - 7