Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Aire ACP9001 Inglés_Maquetación 1 04/01/18 17:40 Página 120
PHENOMENON
Air conditioner
can't receive
signal from
remote controller
or remote
controller is
not sensible.
No fan blowed
out from air
conditioner
Set temperature
can't be
adjusted.
TROUBLESHOOTING
Whether it's blocked by
obstacles?
Is sensitivity of remote
controller low?
Whether there's fluorescence
lamp in the room?
Whether air outlet or air inlet
is blocked?
Under heating mode, whether
indoor temperature ireaches
set temperature?
Whether heating mode is
started up just now?
Whether evaporator is defros-
ted?
(Observe it by pulling out the
filter).
Whether the unit operates
under auto mode?
Whether the required tempe-
rature exceeds the tempera-
ture setting range?
- 120 -
SOLUTION
Remove the obstacles.
Check the batteries of
remote controller. If the
power is low, please repla-
ce the batteries.
Move the remote controller
close to air conditioner.
Turn off the fluorescence
lamp and try it again.
Eliminate the obstacles.
The unit will stop blowing
fan after reaching set tem-
perature.
In order to prevent cold
air, air conditioner will
delay for a while to be
started up, which is the
normal phenomenon.
It's the normal phenome-
non.
Air conditioner is defros-
ting.
After deefrosting is finis-
hed,it will resume opera-
tion.
Temperature can't be
adjusted under auto
mode.
Temperature setting
range: 16°C-30°C.
E
N
G
L
I
S
H
Tabla de contenido
