Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
-
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation
location.
5. If required,
change the door
hinges to the right
(see page 7),
6. if required,
have customer
service install the exhaust air
outlet on the dryer (see
page 9).
7. Have the power supply cord
fitted by an authorized
technician
(see page 8).
8. Install exhaust duct if
necessary,
Follow the installation
instructions
supplied
by the
appropriate
manufacturer!
I_If
space is very restrb[ed,
it is
recommended
to fit the initial
parts of the exhaust duct to the
dryer before the dryer is moved
to its final installation
location.
9. Move the dryer to its final
location and align,
Do not slide dryer across the
floor if height-adjustable
feet
have been extended.
Feet and/or
dryer base may be damaged
if
dryer is slid across floor with
height-adjustable
feet extended.
10. Position and then level the
dryer.
The dryer should be level with
all four feet firmly on the
ground. The dryer must not
wobble.
If the dryer is not level
or if it does wobble,
the feet
must be adjusted.
Adlust the
height-ad}ustabte
feet until the
dryer does not rock and is level,
both front-to-back
and
side-to-side.
11. Connect
the exhaust duct to
the exhaust air outlet on the
dryer.
12. Insert plug into the wall
receptacle.
Check list before
using the dryer
1. Check that steps 1-12 have
been implemented
properly.
2. Ensure that the dryer is
connected
to the power supply.
3. Read the operating
instructions
to understand
how your dryer
operates,
4. Conduct
an appliance
test:
I_t Check that the drum is
empty.
L.t Close the dryer door,
L..I Switch the dryer to "Extra
Dry" and then press the
Start button,
L.t After 3-5 minutes press the
Stop button and open the
door.
5. If the interior of the dryer feels
warm, the dryer has been
connected
properly.
Switch the dryer to "OFF".
6. If the dryer does not work,
switch the dryer to "OFF".
Look in the troubleshooting
section (page 24) of the
OPERATING
INSTRUCTIONS
and find the fault.
Preparing
to transport
the dryer - step
by step
1. Rotate the program
selector
to "OFF".
2. Pull out the power supply plug.
3. Disconnect
the exhaust duct
from the exhaust air outlet on
the dryer,
4. Place any accessories
in the
drum,
5. Close the door and secure with
adhesive tape,
6. Screw the height-adiustable
feet of the dryer into the
housing to prevent them from
being damaged
during
transportation.
12
Capítulos
Tabla de contenido
