Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
1
3 _
1
Exhaust a ir outleton the rear of 1he
appliance(standard)
2
Exhaust a ir outleton the side(optional)
3 -
Exhaust a ir outleton theundersideof the
DO NOT assemble
the ductwork
with screws or fasteners that
extend into the duct. They will serve
as an accumulation
point for lint.
Joints should be secured with
aluminum
tape.
More than two 90 ° turns are not
recommended.
For best
performance,
separate all turns by
at least 4 ft. of straight duct,
including
distance
belween
last turn
and exhaust
hood,
Special exhaust air connections
must be obtained
from your dealer
or part supplier for either
connection
type (see page 1 t).
Side exhaust
kit
Bottom
exhaust kit
A qualified
technician
should
change the exhaust air outlet to the
optional
connection
location.
Ductwork
To ensure optimum
performance,
the ducting system of the dryer
should be as short as possible with
a minimum
number of elbows. Your
dryer will work best when the
venting system has as few air flow
restrictions
as possible.
Exhaust
ducling
which is longer than
recommended
may extend drying
Iime, cause lint to accumulate
and
affecl dryer performance
and dryer
life-time,
Fourqnch
(approx.
100 mm)
diameter ducting should be used.
Use either rigid metal or flexible
metal ducting
material,
DO NOT use plastic or non-metal
ducl with this dryer.
All joints should be tight to avoid
leaks. The male end of each duct
section must point away from the
dryer.
Whether connecting
to an exisling
venting system or a new venting
system, make sure that all ducting
is clean and free of lint,
The maximum
permitted
length for
both rigid and flexible metal duct is
shown in the table below.
Numberof
Rigid Duct
Flexible Duct
90°Turns
or Elbows
0
66ft.
45ft.
(2011 cm)
(1372 cm)
1
5611,
3611,
(1707 cm)
2
48ft,
29ft,
(1463 cm)
(884 cm)
3
39 fL
22 fL
(1189 cm)
(671 cm)
4
301l
16ft.
(488 cm)
Note:
Side and bottom
exhaust
installations
have a 90 ° Iurn inside
the dryer, To determine
maximum
exhaust length, add one 90" turn Io
Ihe chart.
Exhaust
vent hood
The exhaust duct must end with an
approved
exhaust vent hood with
swing out damper(s).
DO NOT use
an exhaust vent hood with
magnetic
latches,
To avoid exhaust
restriction,
the
outlel must be a minimum
of
t2 inches (30 cm) above ground
level or any other obslructing
surface.
Required
parts
The parts required for Ihe exhaust
air system (elbows,
lines, exhaust
air outlets) are not included
in
standard delivery of the dryer.
10
Capítulos
Tabla de contenido
