Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Notes For Use; Switching The Appliance On / Off - Profi Care PC-BS 3036 A Manual De Instrucciones

When the charging process of the battery is completed,
you should disconnect the charger immediately. A charge
up to 90 % is considered best.
Conversely, it is also preserving the battery more when
it is not discharged to 0 %. If the possibility arises, you
should already recharge the battery when it is reaching a
charge state of 30 %.
• Storage: Always store batteries in a dry place and at
moderate temperatures between 10 °C and 20 °C.
Also consider the effect of self-discharge! When the ac-
cumulator is already empty, this effect may lead to a deep
discharge resulting in damaging the battery. If you intend
to store the battery for an extended period of time, you
can counteract this effect. We then recommend charging
the battery to approx. 40 % before storage. You should
check the state of charge after not more than a month.

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Check the delivery scope for completeness.
3. Check the appliance for any transport damage, in order
to prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged appliance!
Overview of the Components /
Scope of Delivery
1 Indicator lights
2 ECO button
3 On / off button
4 Carrying handle
5 Power supply connection socket
6 Release buttons for the rechargeable battery pack on
both sides
7 Dust container
8 Base plate of the dust container
9 Opener / locking of the base plate
10 Suction pipe release

11 Suction pipe

12 Floor nozzle release

13 Floor nozzle with turbo brush

14 Crevice nozzle
15 Accessory holder
16 Combined upholstery / brush nozzle
17 PUSH opener / locking of the cover (Outlet filter) 18 Exhaust filter behind the cover
19 Motor housing / hand set
Not Shown
1 × Special brush
1 × Power adapter
1 × Wall holder
46
PC-BS3036A_IM
2 × Wall plug
2 × Screw

Notes for Use

• The appliance is especially suitable for quickly vacuum-
ing small amounts of dry dirt or dust.
• The appliance is operated via charged battery. Charging
is done via the supplied power adapter.
• Direct power supply via power adapter is not possible.
• This rechargeable battery vacuum cleaner is no
adequate replacement for a conventional floor vacuum
cleaner. Especially on shag-pile carpet, the cleaning
performance is not sufficient owing to its design.
• Contaminated filters reduce the suction power of the vac-
uum cleaner. Therefore, we recommend regular cleaning
of the existing dirt filters.
• Ideally, clean the filters whenever they have been subject
to a prolonged use.
• Please regularly check and clean the electric floor
nozzle.
• If necessary, clean heavily soiled floors multiple times
and / or use a conventional 230 V~ floor vacuum cleaner.

Switching the Appliance On / Off

• The button turns the appliance on and off.
• Press the ECO button to toggle between low and high
power level. In ECO mode, you can extend the life cycle
of the rechargeable battery. The LED between the two
buttons will light up.

Start-Up

Suction Pipe
• Insert the suction pipe with the two contact pins into
the connection on the hand appliance. It must audibly
engage.
• To disconnect the suction pipe, press the release (10)
and pull out the pipe at the same time.
• Use the bracket to attach the upholstery / brush nozzle
and the crevice nozzle to the suction tube. This way, you
always have the accessories at hand.
Floor Nozzle with Turbo Brush
• The floor nozzle is suitable for all floor coverings except
for shag-pile carpets.
• During operation, the LEDs on the floor nozzle light up
for better visibility in dark areas.
CAUTION: You cannot replace the LEDs.
• Stick the lower end of the suction pipe onto the connec-
tor on the floor nozzle. Note the contact pins on the floor
nozzle. The suction pipe must audibly s snap into place.
• To disconnect the suction pipe, press the release (12)
and pull out the pipe at the same time.
19.06.19