Tabla de contenido
Idiomas disponibles
Idiomas disponibles
When the charging process of the battery is completed,
you should disconnect the charger immediately. A charge
up to 90 % is considered best.
Conversely, it is also preserving the battery more when
it is not discharged to 0 %. If the possibility arises, you
should already recharge the battery when it is reaching a
charge state of 30 %.
• Storage: Always store batteries in a dry place and at
moderate temperatures between 10 °C and 20 °C.
Also consider the effect of self-discharge! When the
accumulator is already empty, this effect may lead to
a deep discharge resulting in damaging the battery. If
you intend to store the battery for an extended period of
time, you can counteract this effect. We then recommend
charging the battery to approx. 40 % before storage. You
should check the state of charge after not more than a
month.
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Check the delivery scope for completeness.
3. Check the appliance for any transport damage, in order
to prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged appliance!
Overview of the Components /
Scope of Delivery
Figure A
1 Dust container
2 Motor housing
3 MAX button
4 On / off button
5 Rechargeable battery pack
6 Rechargeable battery pack release
7 Dust container latch
Figure B
1 Dust container
2 Motor housing
8 Indicator lights
9 Carrying handle
10 Power supply connection socket
11 Hand set (Figure A)
12 Suction pipe release
13 Nozzle holder
14 Release for suction pipe joint
15 Floor nozzle with turbo brush
16 Floor nozzle release
17 Suction pipe
18 Combined nozzle release
19 Combined gap / brush / upholstery nozzle
20 Extendable special brush
PC-BS3037A_IM
Figures A and D
Wall holder
Not shown
1 × Power adapter
2 × Wall plug
2 × Screw
Notes for Use
• The appliance is especially suitable for quickly vacuum-
ing small amounts of dry dirt or dust.
• The appliance is operated via charged battery. Charging
is done via the supplied power adapter.
• Direct power supply via power adapter is not possible.
• Hang the appliance onto the supplied wall mount when
not in use. It also serves as a charging station.
CAUTION:
The appliance can not stand upright on its own. If you
are not using the wall mount, gently place the vacuum
cleaner on the floor.
• This rechargeable battery vacuum cleaner is no
adequate replacement for a conventional floor vacuum
cleaner. Especially on shag-pile carpet, the cleaning
performance is not sufficient owing to its design.
• Contaminated filters reduce the suction power of the vac-
uum cleaner. Therefore, we recommend regular cleaning
of the existing dirt filters.
• Ideally, clean the filters whenever they have been subject
to a prolonged use.
• Please regularly check and clean the electric floor
nozzle.
• If necessary, clean heavily soiled floors multiple times
and / or use a conventional 230 V~ floor vacuum cleaner.
Switching the Appliance On / Off
• The button (4) turns the appliance on and off.
• Press the MAX button on the back of the handset to
toggle between low and high power levels.
Start-Up
Suction Pipe
• The suction pipe is equipped with a joint. When tilted,
it makes it easier for you to vacuum in places that are
hard to reach. For a rigid suction pipe, let the hinge joint
audibly snap into place.
• Insert the suction pipe with the two contact pins into the
connection on the hand unit. It must audibly engage.
• To disconnect the suction pipe, press the release (12)
and pull out the pipe at the same time.
Floor Nozzle with Turbo Brush
• The floor nozzle is suitable for all floor coverings except
for shag-pile carpets.
47
27.05.19
Capítulos
Tabla de contenido
Solución de problemas
