On Screen Display; Setting The Clock - Aiwa AV-DV95 Manual De Instrucciones

I
ON SCREEN DISPLAY
SETTING THE CLOCK
The receiver provides an "On Screen Display" function to show
the receiver settings on the TV screen. With the TV turned on,
when you operate the receiver buttons or remote control buttons,
the settings appear on the TV screen as well as the receiver
display. The following are examples of the "On Screen Display."
When turning on the receiver, pressing the function
buttons, or tuning in a station
On the right side of the screen, the setting results appear for 5
seconds.
Video
V I DEO 1
Aud\o FM
TAPE OFF
_{ MUT&ltG
TUNER FREQ
87.50 MHz
VOL 10
\
"MUTING ON" continues flashing
until MUTING mode is set to off.
When pressing audio effect buttons
such as SURROUND,
DSP, GEQ, T-BASS, BBE and MANUAL SELECT
On the left side of the screen, the audio effect settings appear
for 5 seconds.
PRO LOG IC OFF
D~P OFF
LVL MAX
R LVL
MAX
GEQ OFF
T-BASS
OFF
BBE
OFF
When pressing
CLOCK or SLEEP buttons on the remote
control
On the left side of the screen, the timer setting and the present
time appear for 5 seconds.
The receiver provides an "On Screen Display" function only when
the TV IS connected to the MONITOR VIDEO OUT jack.
2 1,3
DIGITAUANALOISJBAND
R
;,.
CJCXX3
QKIC2
000
ccl
c1
CLOCK
0::=
00
000,
.Qo
o
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1
2
Press the ENTER button on the main
unit.
The display becomes a little brighter.
Turn the MULTI JOG to designate the hour and
the minute.
The time advances by turning it to right, and decreases by
turning it to left.
The DOWN or UP button is also available. Press the button
repeatedly. To change the time rapidly in 10-minute steps,
hold it down.
Press the ENTER button on the main unit.
The clock starts from 00 seconds.
3
m
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the unit is
activated, and is not a malfunction,
The power economizing mode can be canceled. See page 7 for
details.
To correct the current time
Press the POWER button to turn the unit off. Carry out steps 1
to 3 above.
To display the current time
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
To switch to the 24-hour standard
While the power is on, prese the CLOCK button on the remote
control to display the clock. Then press the DIGITAUANALOG/
BAND button while the clock is displayed.
Repeat the same procedure to restore the 12-hour standard.
If the
clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
21
ENGLISH