Metabo HPT М 12VC Manual De Instrucciones página 12

English
(4) While holding up the base slightly, turn the
motor housing clockwise until the index line
on the motor housing reaches the desired
depth indicated on the scale ring. (Fig. 5)
(5) Close the lever firmly.
2. Adjusting the rotation speed (Model
M12VC only)
The M12VC have an electronic control
system that allows stepless rpm changes.
As shown in Fig. 7 dial position "1" is for
minimum speed and position "6" for
maximum speed.
3. Centering the template guide adapter
WARNING:
(1) Loosen the 2 template guide adapter screws,
so that the template guide adapter can be
moved. (Fig. 8)
(2) Insert the centering gauge through the hole
in the template guide adapter and into the
collet chuck. (Fig. 9)
(3) Tighten the collet chuck by hand.
(4) Tighten the lever. (This aligns the center of
the template guide adapter.)
(5) Tighten the template guide adapter screws,
and pull out the centering gauge.
4. Guiding the router
(1) Template guide (M12VC, M12SC: Optional
accessory)
Use the template guide when employing a
template for producing a large quantitiy of
identically shaped products. (Fig. 10)
As shown in Fig. 11, to install insert template
guide in center hole in template guide
adapter and secure in place with the lock
nut.
A template is a profiling mold made of
plywood or thin lumber. When making a
template, pay particular attention to the
matters cescribed blow and illustrated in
Fig. 12.
12
Be sure to switch power
OFF and disconnect the
plug from the receptacle to
avoid serious trouble.
Dial
5
6
Fig. 7
Screw
Template
Guide Adapter
Fig. 8
Centering
Gauge
Fig. 9
Fig. 10
Template
Guide
Fig. 11
Template
Guide Adapter
Screw
Collet
Chuck
Lever
Template
Lock Nut
Template
Guide Adapter