Protos Integral Instrucciones De Uso página 6

1. Adjustments for perfect comfort of wear and optimal safety
1.1 Adjusting for head size:
Neck
1
Adjustment Straps
3
5
GB
Guard
Push the neck
it snaps into place (with a slight click). In this position you
can see the right and left adjustment
3). Use these to adjust the Protos® Integral safety helmet
to your head size.
2
If you have a helmet with hearing
protection, it is easiest to get at the
adjustment
protectors in the stand-by position
(see Fig. 14).
Push the adaptor button towards
the outer shell. Now you can select
one of the three ride heights by
pushing the button in our out. Here,
too, make sure to make the same
adjustments on both sides!
1.3 Fasten chin strap:
6
guard towards the inside of the helmet until
straps (see circle Fig.
Neck Guard Holder
straps if you put the ear
1.2 Adjusting for ride height:
You make adjustments to se-
lect one of 3 variable ride
heights directly to the left
and right of the neck guard.
4
Slide the adjustment straps (Fig. 3) to the
inside or outside (to adjust for smaller or larger
head size) and fi x them in the desired position.
Please make sure to adjust both sides equally
to ensure that the helmet will sit straight on your
head! The lines on the neck guard
as orientation (see circle).
Once you have adjusted and set both sides,
push the neck guard back into its initial position.
The helmet should now fi t fi rmly but not be
too tight. If the helmet does not fi t your head
comfortably, readjust the settings.
Back snap fastener
Open the chin
strap as shown in
the illustration.
Front snap fasteners
holder serve