Acoustic Signals; Energy Management; Maintenance; Cleaning - BEHA UNITEST TELARIS ISO plus Manual De Instrucciones

PTDB90690001.qxd:PTDB9069-02.qxd

10.1 Acoustic Signals

Confirmation Signal
The confirmation signal is a brief sound, audible e.g.
when starting a measurement. It is audible as con-
firmation that the key pressing has been recog-
nised.
Error Signal
The error signal consists in two short sounds. It in-
dicates the occurrence of an error or that a function
can currently not be carried out. For example, when
pressing the "clear" key, the error signal is emitted,
if no measurement value has been stored in the
memory.
Limit Value Signal
The sound level of this signal is different from the
confirmation signal or from the error signal, the
sound level is higher. It indicates that the measure-
ment value falls below the pre-set limit value. It is
audible either at the end of a measurement or dur-
ing Timer measurement.

11.0 Energy Management

Approximately 5 minutes after the last key pressing
the instrument switches off automatically. (auto
power off). The instrument returns in operation
mode when turning the measurement function se-
lection dial (14) from position "OFF" or when press-
ing the "Start" key (20).

12.0 Maintenance

When operating the instrument in compliance with
the instruction manual, no particular maintenance
is required.

12.1 Cleaning

If the instrument is dirty after daily usage, it is ad-
vised to clean it by using a humid cloth and a mild
household detergent.
Prior to cleaning, ensure that instrument is
switched off and disconnected from external volt-
age supply and any other instruments connected
(such as UUT, control instruments, etc.).
02.10.2008 15:37 Uhr
Never use acid detergents or dissolvants for clean-
ing.
After cleaning, do not use the voltage tester for a pe-
riod of approx. 5 hours.

13.0 Battery Replacement

If the battery symbol appears on the display,
the battery must be replaced.
Prior to battery replacement disconnect the in-
strument from all connected measurement cir-
cuits and test leads.
Switch off the instrument by means of the
measurement function selection dial (19)
and disconnect from all measurement cir-
cuits.
Unscrew the screws on the instrument rear.
Lift battery case cover (by slightly knocking
with the ??ball of thumb).
Remove discharged batteries.
Insert new batteries respecting correct po-
larity (indicated on the bottom of the battery
case) !
Never use other batteries than specified in the
Technical Data section (1.5V Type IEC LR6,
Mignon).
Replace battery case cover and retighten the
screws.
The instrument is ready for operation.
Seite 37
Battery Replacement
37