Introduction/Scope Of Supply - BEHA UNITEST TELARIS ISO plus Manual De Instrucciones

PTDB90690001.qxd:PTDB9069-02.qxd

Introduction/Scope of Supply

References marked on instrument or in instruc-
tion manual:
Warning of a potential danger, comply with in-
struction manual.
Reference. Please use utmost attention.
Caution! Dangerous voltage. Danger of electri-
cal shock.
Continuous double or reinforced insulation
complies with category II IEC 61140.
Symbol for the marking of electrical and elec-
tronic equipment
2002/96/EC).
Conformity symbol, the instrument complies
with the valid directives. It complies with the
EMV Directive (89/336/EEC). It also complies
with the Low Voltage Directive (73/23/EEC).
The instruction manual contains information
and references, necessary for safe operation
and maintenance of the instrument. Prior to
using the instrument (commissioning / as-
sembly) the user is kindly requested to thor-
oughly read the instruction manual and com-
ply with it in all sections.
Failure to read the instruction manual or to
comply with the warnings and references
contained herein can result in serious bodily
injury or instrument damage.
24
02.10.2008 15:36 Uhr
1.0 Introduction/Scope of Supply
You have acquired a high standard measurement in-
strument by the company Ch. BEHA GmbH which
allows to carry out reproducible measurements
over a very long time period. The company Ch.
BEHA GmbH is a member of the world-wide oper-
ating BEHA group. The head office of the BEHA
group is located in Glottertal/Schwarzwald, togeth-
er with the technological centre. The BEHA group is
a leading enterprise for test and measurement in-
struments.
The instrument UNITEST TELARIS ISO plus is
characterised by the following features:
• Determination of the insulation resistance for
(WEEE Directive
• Four integrated measurement voltages 100V,
• Built-in low-ohm measurement at a test current of
• AC and DC voltage measurements up to 500V
• Allows limit value pre-setting for the insulation
• Test lead compensation for precise zero adjust-
• Bargraph
• Backlight allows reading the screen even under
• Timer measurement for fast testing of several
• Plug-in test probe
• Infrared interface for recording the measurement
• Measurement data memory for up to 500 mea-
• Energy management
• Constructed in compliance with DIN VDE 0413, EN
Scope of Supply
1 UNITEST TELARIS ISO plus
6 Batteries, 1.5 V IEC LR6, Mignon
2 Safety test leads, black, red
2 Alligator clamps, black, red
3 Plug-in test probes
1 Carrying holster
1 Instruction manual
Seite 24
electrical systems, conductors, and machines
250V, 500V and 1000V
200mA, in compliance with DIN VDE 0413, Part 4
measurement range
ment in the event of low-ohm measurement
unfavourable lighting conditions
conductors/leads
results on the PC
surement values
61557, IEC 61557, DIN VDE 0411, EN 61010, IEC
61010