Energy Saving Mode; Maintenance And Storage; Troubleshooting; Replacement Parts - Schumacher Electric SL1397 Manual Del Usuario

USING THE WORK LIGHT
5.3
1. Position the jump starter on a flat, stable surface near the intended work area.
2. Ensure the battery clamps are securely clipped on the storage holders.
3. Flip the ON/OFF power switch to the ON position.
4. Press the Battery Status/Light button on the front of the unit for 0.75 second, to turn on the work light.
5. When finished using the work light, press the button for 0.75 second, to turn off the work light.
6. Recharge the unit as soon as possible after each use.

ENERGY SAVING MODE

5.4
If the unit is not used after the ON/OFF power switch is turned on, the unit will go into Energy Saving mode after 10 minutes to prevent battery discharge. Follow these
steps to use any function after Energy Saving mode:
1. Press the ON/OFF power switch to turn the unit ON.
2. The Green Ready/Fail LED will light.
3. After 10 minutes, the USB port and Battery Status/Light function will turn off.
4. After 10 minutes, the Green Ready/Fail LED will turn off.
5. Press the Battery Status/Light button once. The unit is now ready for checking the battery status and using the jump starter, USB and work light.
6.

MAINTENANCE AND STORAGE

Clean the clips and the case each time you are finished using it.
6.1
6.2 Charge battery to full capacity before storage.
Store this unit at the temperatures between - 4°F - + 140°F ( - 20 ˚C - + 60 ˚C).
6.3
6.4 Store clips on their support posts, to ensure they do not come into contact with any metallic surface.
6.5 Never completely discharge the internal battery.
6.6 Charge after each use.
Charge at least once every month, if not in frequent use, to prevent over-discharge.
6.7
7.

TROUBLESHOOTING

PROBLEM
The jump starter won't jump start my car.
The jump starter will not operate.
The battery in the jump starter won't hold a charge.
Ready/Fail LED Behavior
Green LED lit solid
Red LED lit solid and buzzer sounds continuously
No LED lit and no buzzer beep
Flashing LED alternates between Green and Red
Red LED flashing and buzzer sounds twice per second
Red LED flashing and buzzer sounds every second
Battery Status LED Behavior
Red, Yellow and Green LEDs flash at the same time.
8.

REPLACEMENT PARTS

Micro USB-USB charging cable .............................................................................................. 3899003781Z
9.

BEFORE RETURNING FOR REPAIRS

For information about troubleshooting, contact customer service for assistance:
[email protected] | www.batterychargers.com | or call 1-800-621-5485
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA)
number from Customer Service at Schumacher Electric Corporation.
POSSIBLE CAUSE
Clamps are not making a good connection to the
battery.
Connections are reversed.
The jump starter's battery is not charged.
The vehicle's battery is defective.
The jump starter is not turned on.
Low temperature protection.
The battery is bad (will not accept a charge).
Ready to jump start
Short circuit protection
Battery low voltage protection
Reverse charging protection
Reverse polarity protection
High temperature protection for unit
High temperature protection for internal battery
• 5 •
SOLUTION
Check for poor connection to battery and frame.
Make sure connection points are clean.
Disconnect the jump starter and reverse the clamps.
Press the Battery Status button on the front of the
unit. The LEDs will indicate the status of charge.
Have the battery checked.
Press ON/OFF switch to turn on the jump starter.
Use the USB adaptor to charge and activate.
Have the battery checked.