Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Contro|s
at a G|anCeoooooooooooooooooo,,,,,,,,,,ooooooooo
Cycles
Heavy Wash is for
heavily soiled dish
loads.
_oo®eeo®eeoeoooo®®ee®®eeeoooo,
Normal Wash
is for
loads containing
dishes
with normal
amounts
of
food soils.
Prewash
Prerinse
Main Wash
Prerinse
Hi-Temp
Rinse
Dry
_=®e®eeeooeooomo®e
Prewash
Main Wash
Prerinse
Hi-Temp
Rinse
Dry
9.8 Gal.
Light Wash is f\_r
washing
lightly soiled
loads.
_oooo=o®eeeoooooooe_®®eoooooo,
Rinse Only is for
rinsing dishes being held
until the dishwasher
is
full. This helps reduce
the potential
for odors.
Main Wash
Prerinse
Hi-Temp
Rinse
Dry
_=o®eeeeeooooomo®e
Rinse
5.8 Gal.
Options
Select Sanitize
to clean and sanitize
dishware
with any
of the cycle choices (except Rinse Only).
Because
this option
adds heat and water
temperature
checks
to the main wash and final rinse, it can also be
selected
to e]_ance
washing
and drying results
for all
load types.
Select Heated
Dry to turn on the heating element during
dry for enhanced drying results. When Heated
Dry is not
selected,
towel drying of some items may be necessary
and more moisture
may be noticed adhering
to the dish-
washer
interior.
With either dry option, it is normal
to
notice vapor escaping
from the door vent.
To drain the dishwasher
and then turn it oft, press the
Drain/Off
once. Press Drain/Off
twice to turn the dish-
washer off without draining.
indicator Lights
The SANITIZED
light illuminates
at the end of the
Light,
Normal
or Heavy
Wash
cycle when the Sanitize
option has been selected and conditions
have been met to
achieve
sanitization.
The CLEAN
light is illuminated
at the end of the cycle
and remains lit until the door has been open for 30 seconds
continuously.
The DRY light is illuminated
during the entire dry period
and goes out when the cycle is completed.
The WASH
light is illuminated
during all rinse and wash
portions
of the cycle
The HEATING
DELAY
light illuminates
when the cycle
is being extended
to heat the water to proper temperature.
Delay/Resume
The Delay/Resume
option can be used to automatically
start the cycle at a later time, such as during
off-peak
hours for reduced
energy
cost or to reduce daytime
heat
buildup
in the home.
To Set Up a Delay:
Select the appropriate
cycle and options
for the load.
Press
the
Delay/Resume
pad
until
the
desired
amount
of delay time (2, 4 or 6 hours) is selected.
The delay time will begin counting
down when the
pad is released.
The DELAY
HOURS
indicator
light will remain lit
until the delay time has counted
down.
The cycle
will automatically
start as soon as the
delay time expires.
To Cancel
a Delay:
Wait at least 2 seconds, then press the Delay/Resume
pad
again. The indicator
light will go out and the cycle will
start or resume immediately.
6
Tabla de contenido
