Important Safety Instructions For Battery Packs - Craftsman CMCHT98022 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WARNING:
THE CHARGER SUPPLIED WITH THIS PRODUCT IS INTENDED TO BE PLUGGED IN SUCH THAT
IT IS CORRECTLY ORIENTATED IN A VERTICAL OR FLOOR MOUNT POSITION.
• DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger
and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designatedC
batteries. Any other uses may result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to
damage or stress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of
fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the
gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using
more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.
Ampere Rating
More Than Not More
0
6
10
12
• Do not place any object on top of charger or place the charger on a soft surface that might block the
ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat
source. The charger is ventilated through slots in the top and the bottom of the housing.
• Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat,
stable surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug — have them replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way.
Take it to an authorized service center.
• Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to
use it on any other voltage.

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY PACKS

WARNING:
For safe operation, read this manual and manuals originally supplied with tool before using the charger.
The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety
instructions below. Then follow charging procedures outlined.
• Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can
explode in a fire. Toxic fumes and materials are created when battery packs are burned.
• Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or
dust. Inserting or removing the battery from the charger may ignite the dust or fumes.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120 V
0-25 (0-7,6m)
0-50
240 V
(0-15,2m)
Than
6
18
10
18
12
16
16
14
READ ALL INSTRUCTIONS
26-50
51-100
(7,6-15,2m)
(15,2-30,4m)
51-100
101-200
(15,2-30,4m)
(30,4-60,9m)
American Wire Gauge
16
16
1
16
4
1
14
6
12
Not Recommended
5
raftsman
rechargeable
101-150
(30,4-45,7m)
201-300
(60,9-91,4m)
14
12
12
Tabla de contenido
loading

Tabla de contenido