Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Feed the board at a continuous even rate of speed.
Any hesitation or stopping could cause a "step" to be
cut on the edge of the board.
Figure 13 - Feeding Workpiece
•
As the trailing hand passes over the cutterhead,
remove the leading hand.
•
Continue feeding while placing the leading hand
behind the trailing hand until the entire length of the
board is cut.
Figure 14 - Guiding Workpiece
•
Feed with the grain whenever possible.
Rotation
Figure 16- Feeding with Push Blocks
•
Grasp the hold-down/push-blocks
firmly.
•
Position the push-blocks flat on top of workpiece and
push the workpiece down against the table.
•
Use a hand-over-hand
motion to maintain control
over the workpiece at all times.
•
When planing workpiece between 1__ 3/4,, a nd nar-
rower than the push-blocks, tilt the push-blocks so
that it clears the cutterhead guard while feeding.
BEVELING
AND CHAMFERING
Refer to Figure 17.
•
The fence on the jointer/planer
is adjustable from
45 ° inward to 45 ° outward. Adjust the fence to the
desired angle and tighten fence lock knobs. You may
require to lift the positive pin to move fence.
•
Beveling refers to cutting the entire edge of a board
at an angle. Bevelling may require several passes
due to the depth of cut needed.
•
Chamfering refers to removing only the corner of the
edge of a board. Normally a chamfer is made on one
pass; so a _/_6" depth of cut is made.
Bevel Edge
_n
Rotation
Figure 15 - Direction of Feed
•
If the nature of the workpiece is such that it must be fed
against the grain, take very light cuts and feed slowly.
•
When using long workpieces, to avoid injury from slips
or kickbacks and to exert even pressure on the cutter-
head, use extra supports (see Recommended
Accessories, page 13) at both infeed and outfeed ends.
USING HOLD DOWN/PUSH
BLOCKS
Refer to Figure 16.
•
Always use hold-down/push-blocks
when jointing, or
rabbeting wood that is narrower than 3", planing
wood thinner than 3".
Chamfer Edge
Figure 17 - Beveling and Chamfering
USING A VACUUM
HOSE
A standard dust collection hose can be attached to the
exhaust port (2 _/2"Dia.) on the rear of the jointer. Jointer
will perform properly at all depths of cuts up to _/8" w hen
used with a dust collecting system. (See "Avoid Damage
to Blades", page 7.) To attach a dust collecting system:
•
Insert the dust collection hose to the exhaust port on
the rear of the jointer.
•
Turn the dust collecting system on.
•
Turn the jointer on.
•
Periodically replace/empty
bag in the dust collecting
system.
8
Tabla de contenido
