Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Use recommended
accessories (refer to page 13).
Use of improper accessories
may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
° Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
•
Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
•
Feed work into blade or cutter against direction of
rotation.
CAUTION:
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figure 1 below.
Check for shipping damage. If damage has occurred, a
claim must be filed with carrier. Check for complete-
ness. Immediately report missing parts to dealer.
The jointer/planer is shipped complete in one carton.
Additional parts which need to be fastened to
jointer/planer should be located and accounted for
before assembling.
A
Jointer Bed Assembly
B
Fence
C
Push Blocks (2)
D
Left Trunnion
E
Right Trunnion
Hardware bag includes:
•
5-0.8 x 8mm Socket Head Bolts (4)
° 5mm Lockwasher (4)
•
5-0.8 x 10mm Flat Head Screw (4)
\
°
E
Figure 1 - Unpacking
Refer to Figure 2.
ASSEMBLE
FENCE
•
Attach fence assembly to jointer bed assembly using
four socket head bolts and lock washers.
•
Make sure that the fence assembly is secure.
Figure 2 - Assemble Fence
The jointer/planer weighs approximately 40 Ibs. when
completely assembled. The jointer/planer
must be
installed in a place with ample lighting and correct
power supply. To install jointer/planter:
•
Make sure there is plenty of room for moving the
workpiece through the entire cut. There must be
enough room that neither the operators nor the
bystanders will have to stand in line with the wood
while using the tool.
•
Jointer/planer can be installed on work using bolts,
Iockwashers and hex nuts (not supplied) or using
wood screws (not supplied).
° The 1/4"holes (see Figure 3, page 4) are intended for
installing jointer/planer using bolts, Iockwashers and
hex nuts.
° The 5/32" h oles (see Figure 3, page 4) are intended
for installing jointer/planer using wood screws.
•
Bolt or clamp the jointer/planer to a firm, level surface.
•
Make sure the jointer/planer does not rock and the
tables are level.
3
ASSEMBLE
TRUNNIONS
TO FENCE
The trunnion with scale is the left trunnion and the trun-
nion with plunger is the right trunnion. Trunnions are
attached to the rear of the fence. To attach trunnion:
•
Attach the left trunnion to the left rear end of the
fence by fastening two 5-0.8 x 10mm flat head
screws from the front side of the fence.
•
Attach the right trunnion to the right rear end of the
fence by fastening two 5-0.8 x 10mm flat head
screws from the front side of the fence.
•
Make sure the trunnions are secure and the screw
heads are inside the fence.
Tabla de contenido
