Test Bolt Alignment; Install The Touchscreen Assembly; Install The Touchscreen On The Outside Of The Door - Schlage CONNECT Guia De Instalacion

6e Test bolt alignment.
1. Close the door.
2. Insert a flathead screwdriver into the slot in the bolt, as shown.
3. Rotate the screwdriver toward the door edge to extend the bolt into the hole in the frame.
This operation should be smooth. You should be able to rotate the screwdriver 90˚, fully
extending the bolt.
4. If the operation was not smooth, or if the bolt did not fully extend, adjust your frame and/or
door preparation. Go to answers.schlage.com and watch the video Proper Alignment of
Door and Frame for a Smoothly Operating Lock for further instructions.
5. Retract (unlock) the bolt before continuing to step 7.
L If the deadbolt continues to rub against the strike, contact Customer Support for an
alternate strike with an additional .060" (2 mm) clearance.
7

Install the Touchscreen Assembly.

7a

Install the Touchscreen on the outside of the door.

L The clips snap into the crossbore (see step 4 on page 5) to assist in holding the
keypad on the door.
L The Touchscreen Assembly should install smoothly. If it does not, check that the bolt is set
to the correct backset (see step 6a on page 6).
L NOTE: If you have a crossbore (see step 4 on page 5) that is slightly less than 2Z\,"
(54 mm), the lock may not install smoothly. You can remove the spacer. Always remove
the spacer for a 1Z\x" (38 mm) crossbore. See Spacer Removal on page 15 before
continuing.
8
CAUTION
Test from the inside to
avoid being locked out!
Clips snap into
the crossbore.
If you can rotate the
screwdriver a full
90˚, then the bolt is
fully extended.
Retract the bolt
before continuing
to step 6.
Align the tab
with the notch.
Route the cable
under the bolt.