Preparation; Setting And Adjustment Of The Projector - Sony VPLL-3003 Manual De Instrucciones

Preparation

1
Turn on the projector.
The projection lens moves automatically to the
initial position.
Note
When the projection lens moves to the initial
position, make sure that the lens does not strike
anything.
2
Move the shift's vertical direction close to the
center.
Press the SHIFT button on the Remote Commander
or the control panel of the projector, and adjust with
V/v.

Setting and adjustment of the projector

1
Check if the upper side and lower side of the picture are parallel.
If not, install the projector in a position parallel to the projection surface (a=b).
Image distortion
Notes
• Set the image inversion of the projector so that the top
and bottom, left and right of the image is projected
correctly depending on the projection environment.
• The initial shift position of the projection lens is the
top shift position of the suspended condition and the
bottom shift position of the floor position condition.
Before setting the projector, the shift should be near
the center for the fine adjustment of the vertical
direction.
Installation state to the projection
surface (Top view)
a b
a > b
a
b
a < b
25
Adjusting