Removing The Projection Lens Attached To The Projector; Attaching The Optical Filter - Sony VPLL-3003 Manual De Instrucciones

Removing the Projection Lens
attached to the Projector
1
Return the projection lens to the center position.
While the projector is turned on, press the LENS
SHIFT button on the Remote Commander, then
press the RESET button on it. The projection lens
returns to the center position.
Note
The projection lens cannot be removed unless it has
returned to the center position.
2
Turn off the projector, then unplug the AC power
cord from the wall outlet.
Caution
When replacing the lens, your eyes may be
damaged if a strong light accidently gets into
your eyes. Before replacing the lens, turn off the
projector and then unplug the AC power cord.
3
While pressing and holding down the LENS
RELEASE button, rotate the projection lens
counterclockwise to pull out the lens straight.
LENS RELEASE button

Attaching the Optical Filter

Note
When the projection lens VPLL-3003 is used, attach the
optical filter. When the optical filter is not used, the
image may be not displayed correctly.
22
Attaching the Projection Lens
Projection lens
1
Hold the lower part of the holder using a tweezer,
pull it downwards to the front, and remove the glass
attached to the projector.
Lower part of the holder
2
Attach the optical filter (supplied) using a tweezer.
Put the protrusion of the upper part of the optical
filter into the prism base of the projector (1) and
insert the lower part until it locks with a click (2).
Optical filter Protrusion
Lower part
Point which can be picked up
with a tweezer
Note
If you do not operate the optical filter correctly during
attaching or removing, it may be corrupted.
Tip
Cleaning the Optical Filter
• Before cleaning:
Be sure that the power is turned off and the light
source is turned off.
• Cleaning the optical filter:
Wipe the filter gently with a tissue paper which is
moistened with potable water. Never use solvents
such as alcohol, benzene, thinner, acid, alkaline or
abrasive detergent, or a chemical cleaning cloth,
which may damage the surface of the filter.
Prism base