Weed Eater VS2000BV Manual De Instrucciones página 8

• To reduce noise _eveis, operate power
blowers at the lowest possible throttle
speed to do the job
• Use rakes and brooms ta loosen debds be-
fore blowing.
• In dusty conditions, slightly dampen sur-
faces or use a mister attachment when wa-
ter is available.
• Conserve water by using power blowers
instead of hoses for many lawn and garden
applications, including areas such as gutters,
screens, patios, grills, porches, and gardens.
• Watah out for children, pets, open windows,
or freshly washed cars. Blow debris away
safely.
• Use the full blower nozzle extension so the
air stream can work close to the ground.
• After using blowers and other equipment,
CLEAN UP! Dispose of debris in trash re-
ceptacles.
BEFORE STARTING ENGINE
_WARNING:
Be sure to read the fuel
information in the safety rules before you be-
gin. If you do not understand the safety rules,
do not attempt to fuel your unit. Call
1-800-554-6723.
FUELING ENGINE
Ai_WARNING:
Remove fuet cap s_owly
when refueling.
This engine is certified to operate on unleaded
gasoline. Before operation, gasoline must be
mixed with a good quality synthetic 2-cycle
air-cooled engine oil designed to be mixed at a
ratio of 40:1. PoularyVVEED EATER brand
synthetic oil is recommended. Mix gasoline and
oil at a ratio of 40:1. A 40:1 ratio is obtained by
mixing 3.2 ounces (95 ml) of oil with 1 gallon (4
liters) of unleaded gasoline DO NOT USE
automotive oil or marine oil. These oils will
cause engine damage. When mixing fuel, follow
instructions printed on container Once oil is
added to gasoline, shake container momentariEy
to assure that the fuel is thoroughly mixed.
Always read and follow the safety rules relating
to fue{ before fueling your unit.
IMPORTANT
Experience indicates that a_cohol blended
fuels (called gasohol or using ethanol or
methanef) can attract moisture which leads to
separation and formation of acids during
storage. Acidic gas can damage the fue{
system of an engine while in storage. To avoid
engine problems, empty the fuel system
before storage for 30 days or longer. Drain the
gas tank, startthe engine and let it run until the
fuel lines and carburetor are empty. Use fresh
fuel next season. Never use engine or
carburetor cleaner products in the fuel tank or
permanent damage may occur.
-8-
HOW TO STOP YOUR ENGINE
• Release the throttle trigger.
• Push and hold the STOP switch in the
STOP position until the engine stops.
HOW TO START YOUR ENGINE
_WARNING:
You MUST make sure
the tubes are secure before using the unit.
• Fuel engine Move at least 10 feet (3 me-
ters) away from the fueling site.
• Hold the unit in the starting position as
shown. Make sure the blower end is di-
rected away from people, animals, glass,
and solid objects.
STARTING POSITION
/
Slower
/
_WARNING:
When starting engine,
hold the unit as i_lustrated. Do not set unit on any
surface except a clean, hard area when starting
engine or while engine is running. Debris such
as gravel, sand, dust, grass, etc. could be
picked up by the air intake and thrown out
through the discharge opening, damaging the
unit or property, or causing serious injury to by-
standers or the o
STARTING A COLD ENGINE (or warm
engine after running out of fuel)
1. Slowly press the primer bulb 6 times.
2. Move choke lever to the FULL CHOKE
position.
3. Squeeze the throttle trigger fully and hold
through all remefeft_J steps
Starter
Handle
Choke
Primer
Bulb