Weed Eater VS2000BV Manual De Instrucciones página 10

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Cleaning
the air filter:
1. Clean the cover and the area around
it to
keep debds from fal+ing into the carburetor
chamber
when the cover
is removed
NOTE:
Move choke lever to RUN position
before opening air fi_ter cover.
2. Open
air filter cover
by pushing
button
(see illustration)
Remove
air filter.
NOTE:
Do not clean filter in gasoline or other
flammable
solvent. Doing so can create a fire
hazard or produce
harrc_JI evaporative
emis-
sions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Apply
a few
drops
of oil to the filter;
squeeze
filter to distribute
oil.
6. Replace parts.
REPLACE
SPARK
PLUG
Replace spark
p_ug each year to ensure the
engine
starts
easier
and
runs
better.
Set
spark
plug gap at 0.025 inch (0.6 mm)
Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and dis-
card.
3. Replace
with
Champion
RCJ-6Y
spark
plug and tighten secure{y
with a 3/4 inch
(19 mm) socket
wrench.
4. Reinstall the spark plug boot.
REPLACE
FUEL
FILTER
To replace fuel filter, drain unit by run ning itdry
of fuel, then remove fuel cap/retainer
assem-
bly from tank
Purl fitter from tank and remove
it from the fuel line. Install new fuel filter on fuel
line; reinstal+ parts
Fuel Filter
CHECK
MUFFLER
MOUNTING
SCREWS
Once each year, ensure muffler mounting
screws are tightened securely to prevent
damage.
j-
Muffler
' Mounting
Screw
INSPECT
MUFFLER
AND
SPARK
ARRESTING
SCREEN
WARNING:
The muffler on this prod-
uct contains
chemicals
known to the State of
Catifomia
to cause cancer.
As the unit is used, carbon deposits
build up
on the muffler
and spark
arresting
screen,
and must be removed to avoid creating
a fire
hazard
or affecting
engine performance
Muffler Cover
Spark
'_
Arresting
/
/ Hood
/
Screws
Replace the spark arresting
screen every 50
hours of operation
or if any damage
or breaks
in the screen are noted
NOTE:
Do not attempt to c_ean the spark ar-
resting screen.
1. Remove
3 screws
from muffler cover.
Remove
muffler cover
2. Loosen
and remove
4 screws
from the
muffler hood.
3. Remove the muffler hood and spark arrest-
ing screen.
4. Install new spark arresting
screen.
5. Reinstalt muffler hood and 4 screws. Tight-
en screws
securely.
6. Reinstalt
muffler
cover
and
3 screws.
Tighten securely.
NOTE:
if any part of the muffler is cracked,
broken
or damaged,
we recommend
that the
muffler be replaced.
-10-
Tabla de contenido
loading

Tabla de contenido