Triton TSPS 450 Instrucciones De Uso página 7

Sanding
WARNING: Do not sand metal with this sander. Sanding metal will cause sparks that may
ignite wood and dust particles on the sander or in the workshop
Note: The spindle rotates in an anti-clockwise direction
1. Check the machine is mounted securely on the workbench and the Spindle Lock Nut (6)
is fastened correctly with appropriate sanding sleeve and table insert, in accordance with
guidance in 'Assembly'
2. Wear appropriate safety equipment, including face mask and safety glasses, then switch
on the dust extraction system (if available)
3. Turn the sander ON and allow the motor to reach full speed
IMPORTANT: Feed the workpiece gradually, AGAINST the direction of rotation, onto the sanding
sleeve. Failure to do this could force the workpiece away from the sanding sleeve with risk of
injury. Do not force the workpiece or apply excessive force.
4. When finished, turn off the machine and disconnect from mains power
Accessories
• A range of accessories and consumables, including TSS80G, TSS150G, TSS240G Sanding
Sleeves are available from your Triton stockist. Spare parts can be obtained from
toolsparesonline.com
Maintenance
WARNING: Ensure the tool is switched off and the plug is removed from the power point
before making any adjustments or carrying out maintenance.
• Any damage to this tool should be repaired and carefully inspected before use, by qualified
repair technician
• Have your power tool serviced by a qualified repair technician using only identical
replacement parts. This will ensure that the safety of the power tool is maintained
General Inspection
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Power Cord Maintenance
If the supply cord needs replacing, the task must be carried out by the manufacturer, the
manufacturer's agent, or an authorised service centre in order to avoid a safety hazard.
Cleaning
1. Remove dust and dirt regularly. Frequently blow or vacuum dust away from all sander
parts and the motor housing
2. Periodically remove the table insert and lower washer from the spindle and remove any
dust accumulation in the table insert area
3. Re-lubricate all moving parts at regular intervals
4. Never use caustic agents to clean plastic parts
Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp
cloth is recommended. Water must never come into contact with the tool.
Storage
• Store this tool carefully in a secure, dry place out of the reach of children. If the tool is
permanently setup in a workshop or garage ensure access is restricted to prevent children
operating the tool.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
GB
7