Service And Maintenance; 10 Environment - Festool VN-HK 85 130x16-25 Manual De Instrucciones

GB VN-HK85 130X16-25
– Always check that the indexable inserts are firm-
ly seated and undamaged before use; replace
them if necessary.
– Always hold the machine with two hands at the
handles when performing work. This reduces
the risk of injury and is a prerequisite for precise
work.
Wear protective goggles.
Wear a dust mask.
– Do not make angled cuts or plunge cuts.
– Not suitable for freehand use. Only use together
with a guide rail, a cross cutting guide rail or a
parallel stop.
– Always carry out routing work with the speed set
to 6.
– Follow the safety instructions on using the porta-
ble circular saw HK 85.

Routing using a scribe mark: The gauge mark-
ers indicate the routing path without a guide
rail.
9

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the

socket before performing maintenance work on
the machine!
All maintenance and repair work which requires

the motor housing to be opened must only be
carried out by an authorised service workshop.
12
Regular cleaning of the machine, above all
the adjustment devices and the guides, is an
important safety factor.
Observe the following instructions:
Use an extractor on all openings of the power

tool to remove chips and splinters.
The pendulum guard must always be able to

move freely and close independently. Always
keep the area around the pendulum guard
clean. Clear from dust and chippings by blowing
out with compressed air or using a brush.
Clean the adjustable grooving cutter and the

groove unit regularly. Resin from light alloys
must only be removed using thinners that do not
affect the mechanical properties of the material
(pH value 4.5 - 8).
Blunt tools
Always use original indexable inserts.
Remove the indexable inserts from the ad-

justable grooving cutter by undoing the screw.
Clean all parts of the adjustable grooving cutter

and its blade compartments.
Turn the indexable inserts or recondition/re-

place them.
Secure the indexable inserts in place using

countersunk screws (M5) and tighten them (<3
Nm).

10 Environment

Do not dispose of the device as domestic waste!
Dispose of machines, accessories and packaging at
an environmentally responsible recycling centre.
Observe the respective national regulations.
Information on REACh: www.festool.com/reach