Orbegozo BCT 3850 Manual De Instrucciones página 13

BCT 3850
be used
5. Heating up the unit for about 5-10 minutes before beginning the grilling progress.
Set the desired temperature by means of the control unit 0/MAX. The check lamp
light up; the heating element heats up simultaneously. As soon as the set
temperature is attained, the check lamp goes off. If the heating rods cool down too
much, the check lamp lights again to indicate that the heating element is being
heated again.
6. Now you can put the materials to be grilled on the grill grating. Deep frozen grilling
material needs to be thawed completely before grilling.
7. To grill the material uniformly, it should be turned often while grilling. The duration
of grilling depends on the stuff to be grilled.
8. To switch off the grill, rotate the rotary control 0/MAX to 0 and pull the plug out
from the socket.
9. You may pull out the grill stack, the grill grating, the control unit only after the unit
has cooled down completely.
10. The door or the outer surface may get hot when the appliance is operating.
NOTE
CLEANING AND CARE
1. In addition to this, you must observe the safety information.
2. Allow the unit to cool down completely and then pull out the power plug, before
cleaning the unit.
3. To take the heating element out.
4. The control unit must never be dipped in any fluid. for cleaning the outside, use a
lightly damp cloth.
5. You can clean the grill stack, wind protection, grill grating, the collecting tray hot
water.
6. Let the unit dry completely, before connecting it to the mains again.
7. Do not use sharp or abrasive cleaning material.
The grill grating can be set at three
different levels. The higher the grill
grating, the lower the grilling temperature.
13