Change Light Bulbs; Motion Detector - Overview; Reset - Open/Close Travel Limit; Carriage Engage/Disengage - Genie CHAINMAX 1000 Manual De Operación Y Mantenimiento

CHANGE LIGHT BULBS

• Observe all safety warning and precautions!
Improper light bulb removal or replacement
could result in Death or Serious Injury.
• Disconnect power from opener before
beginning this task.
• When replacing light cover, make sure wires are
not pinched or near moving parts.
1. Disconnect power to door opener.
• Open powerhead light cover.
• Remove light bulb(s).
• Replace with maximum 100 Watt light bulb(s).
– Do NOT use light bulbs with greater than
100 Watt rating.
• Close powerhead light cover.
2. Reconnect power to door opener.
• Test light operation.
MOTION DETECTOR* - OVERVIEW
(Not available on all models)
Powerheads equipped with a motion detector
sensor provide additional security when
exiting or entering the garage area.
*This sensor works by detecting body heat. Range of detection may be
reduced when the temperature in the garage is close to body temperature.
NOTE: Detector positioning on the powerhead provides
for monitoring below the powerhead.
OPERATION
• Detector sensor is always ON. There are NO user
controls or adjustments.
• Lights automatically turn ON when a change is
detected and will turn OFF after 4 minutes of no
change.
• Motion detector sensor will not turn OFF lighting
turned ON at the wall console .
• Lighting turned ON at the wall console will remain
ON until wall console turns lighting OFF or opener
is used.
Motion Detector

RESET - OPEN/CLOSE TRAVEL LIMIT

Performing all ten (10) Limits/Force setting steps
(pages 6-7) erases previous Limits/Force settings.
NOTE: The opener will not close the door
automatically unless the Safe-T-Beam® System is
installed and Limits are programmed.
©2011 The Genie Company
WARNING

CARRIAGE ENGAGE/DISENGAGE

Use Release Handle to manually connect or release
chain bullet to Carriage.
TO RELEASE CARRIAGE:
1. Pull handle DOWN then let go.
2. Manually move door until carriage releases from bullet.
3. Raise or lower door manually.
N O T
F D O C E
O R BE
C O M
PU L L ES O
D O W BS TR
N O N U TE
H A N D
Release D
E
Handle PULL
TO RECONNECT CARRIAGE:
1. Verify RED block is in the UP position.
2. Manually move door until carriage engages bullet.
3. Raise or lower door using remote or wall console.
FIG. 6-3 Carriage Release
ENGAGE (for installation)
TO REENGAGE PULL
DOWN AND TOWARD
POWERHEAD THEN
LET GO
TO RELEASE or RECONNECT CARRIAGE,
PULL DOWN AND LET GO
FIG. 6-4 Carriage Release
3/2011
DOOR
DOOR DOOR
DISENGAGE (for installation)
TO DISENGAGE
PULL DOWN AND
TOWARDS DOOR
THEN LET GO
(cut away view)
19