Package Contents - AUDIOLINE Watch & Care V160 Manual De Instrucciones

Starting Up
Starting Up
a
Important: please make sure you've read the safety information on page 26 before you set up
your system.The data transmitted (image and/or sound) are digitally coded.

Package contents

• 1 camera unit (transmitter)
• 1 monitor unit (receiver)
• 1 rechargeable battery pack for the receiver
• 1 power adapter plug for the transmitter
• 1 power adapter plug for the receiver
• wall mounting material (bracket / dowel / screws)
• 1 operating manual
Receiver (parent unit)
1. Remove the plastic protective film from the front of the unit.
Insert the battery supplied into the battery compartment.
It will only fit one way round.
2. Replace the battery compartment cover by aligning the cover flat
against the battery compartment, then slide it towards the centre
of the Parent unit until it clicks into place.
Warning: Only use the battery supplied. Using another type could permanently damage the unit.
Battery performance
The operating time for using the rechargeable battery is limited. It will last for approximately 6 hours in standby
mode but this will vary depending on the sensitivity level you have set, your actual use and the age of the
battery. Therefore, if you want to monitor your baby for long periods we strongly recommend you connect the
power adaptor to the Parent unit, especially at night. Please note that new batteries do not reach full capacity
until they have been in normal use for several days. The charge capacity of rechargeable batteries will reduce
with time as they wear out, so reducing the performance time of the Parent unit. Eventually they will need to be
replaced.
Removing the battery
If you ever need to remove the battery, unplug the power adaptor and then open the battery compartment
cover. Move the battery release tab to the right to release the battery.
1. Plug the power adaptor cable into the socket on the side of the Parent unit and plug the other end into the
mains power and switch on. The battery light on the front of the Parent unit will turn on while the battery is
charging.
2. Leave the battery to charge continuously for 12 hours before you switch the Parent unit on. When the
battery is fully charged the light on the side of the Parent unit will turn off.
3. Once the Parent unit battery has fully charged, press the On/Off-button on the Parent unit until the screen
becomes active. The battery icon on the top line of the screen will be solid to indicate that the battery is
fully charged.
Battery release tab
Antenna
Release
Antenna
Release
19
GB