CENTROTEC tool chuck [6]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Before working with the CENTROTEC tool
chuck, set the selector switch [1-5] to the drill
symbol.
6
1
2
Auxiliary handle [7-1]
We recommend working with an additional
handle [7-1] to ensure a safe, non-tiring
working posture.
Attaching the additional handle [7]
Attach the additional handle [7-1] to the neck of
the gear housing.
Turn the grip anticlockwise until the additional
handle [7-1] is secured in position.
14
click
3
click
4
5
7
7-1
1
2
Depth stop [7-2]
The drilling depth can be adjusted using the
depth stop [7-2].
Attaching the depth stop [7-2]
Unscrew the additional handle [7-1] by turning
the grip anticlockwise.
Insert the depth stop [7-2] in the additional han-
dle [7-1].
Pull out the depth stop [7-2] until the distance
between the tip of the drill and the tip of the
depth stop corresponds to the desired drilling
depth.
Tighten the grip on the additional handle [7-1]
again.
Extraction
Please observe the safety regulations applicable
in your country for dust. The relevant limit values
must be observed at the workstation. A dust ex-
tractor may be required for corresponding dust ex-
posure and depending on regulations. Festool of-
fers a drilling dust nozzle in the accessories sys-
tem.
7-2