Statusindicator; Child Lock - LG WM2101H Serie Manual Del Propietário

1. Prewash
• Use this option for loads that need pretreatment.
Adds 16 minutes prewash and drain.
2. Rinse+Spin
• Use this option to rinse and then spin.
3. Quick Cycle
• The Quick Cycle offers a quick cycle time.
• Suggested uses include freshening newly purchased
clothes, or clothing that has been packed away.
4. Stain cycle
• Adds time to the wash and rinse for better stain
removal.
• Automatically provides a rinse.
5. Tub Clean
• A buildup of detergent residue can occur in the
wash tub over time and can lead to a mildewy or
musty smell. The Tub Clean cycle is specially
designed to remove this buildup.
• To start the Tub Clean cycle:
1. Remove any clothing or items from the washer
and close the door.
2. Open the dispenser drawer and add liquid
chlorine bleach to the bleach compartment.
NOTE: Do not add any detergent to the detergent
compartments. Excessive suds may be
produced and leak |Yore the washer.
3. Close the dispenser drawer slowly.
4. Power on the machine, press the "option" and
then select the "Tub Clean".
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door open
to dry around the washer door opening, door
seal and door glass.
_i_ CAUTION: If there are small children in the
house, care must be taken so that
they can not climb into or play
inside the washer while it is open
for drying.
16
EST.TIME REMAINING
• This display shows:
a) the estimated time remaining in the cycle when
operating,
b) the error code when an error has been
detected.
STATUSINDICATOR
• These lights show which portion of the cycle the
washer is operating. (See page 15)
CHILD LOCK
OPTION
PRESS & HOLD 3 SEC
TO SET CHILD LOCK
• Use this option to prevent unwanted use of the
washer. Press and hold OPTION button for 3
seconds to lock/unlock control.
• When Child lock is set, r, ,..__blinks and all buttons
are disabled. You can lock the washer while it is
operating.
DOOR LOCKED
• Lights whenever the door of the washer is locked.
• The door can be unlocked by pressing the
Start/Pause_i _ button to stop the washer.
NOTE: If the water temperature or the level is too
high, the door cannot be unlocked.
Do not try to |brce the door open when
_) lights on.