König Electronic KN-WS600 Manual De Uso página 9

Searching for radio-
controlled clock signal
The antenna icon without signal strength indicates that the past reception is not successful (daily
synchronization is still enabled). To enforce searching of a radio-controlled time signal immediately, press " "
repeatedly until the antenna icon flashes. If reception continues to fail, try other locations later. Place the unit
away from sources of interference such as mobile phones, appliances, TV, etc.
To disable the radio-controlled time reception and stop the daily synchronization, continue pressing " " until
the antenna icon disappears.
CLOCK AND CALENDAR
Press "CLOCK" to toggle the display between time, calendar and day of the week.
Clock and calendar setting:
Note: You need to set the clock and calendar when your weather station cannot receive a radio-controlled
time signal in your location.
- Hold the "CLOCK" button to enter clock setting mode
- Using "▲"or "▼" to adjust and "CLOCK" to confirm, the following values can be set in sequence:
12/24 hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > EXIT
HOME TIME, WORLD (ZONE) TIME
Hold "ZONE" to enter world (zone) time setting mode. Press "▲" or "▼" to enter the desired hour offset value
from –12 to +12 hours. Press "ZONE" to confirm each setting.
Press the "ZONE" button to toggle between home (radio-controlled) time and world (zone) time. The "ZONE"
icon appears when world (zone) time is selected. When zone time is not used, set the zone time to "0".
ALARM SETTING
Press the "ALARM" button to show the alarm time and the "ALARM" icon will appear. Press again to enable or
disable the alarm. The bell icon " " appears when the alarm is enabled.
Hold "ALARM" to enter alarm time setting mode. Press "▲"or "▼" to enter the desired Hour/ Min values and
press "ALARM" to confirm the setting.
SNOOZE AND BACKLIGHT
When the alarm is going off, press SNOOZE/ LIGHT to trigger the snooze function and the "Zz" icon will
appear. To stop the alarm for one day, press the "ALARM" key.
In normal display, press SNOOZE/LIGHT for an extended backlight if the adapter is not connected.
LOW BATTERY INDICATION
Low battery indication is available for the monitor itself and all of the remote sensors. Replace the batteries
and follow the setup procedure in this instruction manual.
Important: Wind direction calibration is required for the anemometer during battery replacement (For details,
refer to the "Calibrating the anemometer and installing batteries" section).
BATTERY DISPOSAL
Replace only with the same or equivalent type recommended by the manufacturer.
Please dispose of old, defective batteries in an environmentally friendly manner in accordance with the
relevant legislation.
SPECIFICATIONS
Indoor temperature:
Outdoor temperature:
Temperature resolution:
Indoor and outdoor humidity:
Humidity resolution:
Channel for temp and humidity:
Wind speed range:
Reception is successful
0°C to + 50°C (+32°F to +122°F)
-20°C to +60°C (-4°F to +140°F)
0.1°C
20% – 99% RH
1% RH
Maximum 3
0 – 30 m/s
0 – 108 km/h
0 – 67 mph
0 – 58.3 knot
0 – 11 Beaufort
9
Antenna icon disappears
Reception failed Reception is disabled