Safety Instructions - Chloride Power Protection POWER LAN+ 750 Manual De Usuario

Safety Instructions

Read the following information carefully!
Failure to follow these instructions could endanger your life, your health, the opera-
tion of the equipment or the security of data.
- The UPS satisfies safety regulations relative to information systems and electronic machi-
nes used in offices. If you have any questions, contact your after sales service centre.
-Use the right packaging for transport to protect the unit.
- After installing the UPS and before starting it up, please study the environmental conditions
described in the chapter on "Technical Data".
- The unit is equipped with a power line in compliance with safety norms and should only be
connected to a grounded plug.
- The OFF button does not isolate the unit from the mains. To disconnect the unit comple-
tely, remove the power cord from the outlet.
- In the event of a disconnection of mains voltage, the built-in battery will continue to supply
energy to the load
- The power cords should be arranged in such a way as to prevent people from stepping on
or tripping over them. When installing the unit, follow the instructions in the chapter on
"Installation and Operation".
- Data transmission lines should not be connected or disconnected during storms.
- Prevent objects from falling into the equipment (necklaces, paper clips, etc.).
- In the event of an emergency (deterioration of the housing, control or line element, pene-
tration of liquids or foreign bodies), disconnect the equipment, remove the connection to
the mains and call your after sales service centre.
- Repairs may only be made by authorised and trained personnel. It is dangerous for the
user to open the unit and attempt to repair it.
- Do not connect loads which could overload the UPS (such as laser printers, vacuum clea-
ners), or charge the unit with direct current (such as medium wave rectifiers in driers)
- When cleaning the UPS, please see the instructions under the section entitled
"Maintenance".
CAUTION:
1. Make sure there is nothing blocking the vent. There should be at least 12 cm between
the UPS and any other object.
2. Do not place the unit near heat sources or in places exposed to direct sunlight, dust,
water or mechanical blows.
3. The equipment should only be installed in areas where the temperature is controlled
and free of conductive contaminants.
4. Use approved connection cables which support at least the voltage and intensity speci-
fied on each model..
5. The incoming and outgoing wires must always be accessible to the user.
6. The sum of the leakage current of the loads connected to the UPS should not exceed a
total of 2.6mA.
7. Before disconnecting the UPS from the mains, disconnect the output cables connected
to the load.
945016.066
Operating Manual
11
UK