GE JAS02 Manual Del Propietario E Instrucciones De Instalación página 28

Cleaning the glass cooktop.
Sugary spillovers (such
as jellies, fudge, candy,
syrups) or melted plastics
can cause pitting of the
surface of your cooktop
(not covered by the warranty) unless the spill
is removed while still hot.
Special care should be
taken when removing hot
substances.
Be sure to use a new,
sharp razor scraper.
Do not use a dull or nicked
blade.
28
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using the
CERAMA BRYTE Ceramic Cooktop Cleaner
®
with the CERAMA BRYTE
Ceramic Cooktops.
If pots with a thin overlay of aluminum or
copper are allowed to boil dry, the overlay
may leave black discoloration on the
cooktop.
Cooktop Seal
To clean the cooktop seal around the edges of the glass, lay a wet cloth on it for a few
minutes, then wipe clean with nonabrasive
cleaners.
Damage from Sugary Spills and Melted Plastic
Turn off all surface units. Remove hot
pans.
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper (CERAMA BRYTE
Cooktop Scraper) to move the spill to
a cool area on the cooktop.
b. Remove the spill with paper towels.
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
(on some models)
Cleaning Pad for
®
Ceramic
®
This should be removed immediately
before heating again or the discoloration
may be permanent.
WARNING:
Carefully check the bottom
of pans for roughness that would scratch the
cooktop.
.
Don't use the surface units again until
all of the residue has been completely
removed.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
GEAppliances.com