Setting Up The Machine; Configure Reel Holder; Inserting Wire-End Ferrules - Weidmuller Crimpfix R Vario Manual De Instrucciones

5

Setting up the machine

The machine has to be set up in the following situations:
– If a different type of wire-end ferrule has to be processed
– Every time the machine is put into operation
During set-up, the following settings must be checked and
adjusted if necessary:
– Reel holder
– Wire-end ferrule reel
– Ferrule cross section
– Crimp length at four positions (see section 5.3).
The machine must be switched off for setting up.

5.1 Configure reel holder

If 16 or 16 S-size wire-end ferrules are to be processed,
the respective reel holder must be widened.
► If a wire-end ferrule reel is attached, remove it (see sec-
tion 5.6).
► Release the two fixing screws (1) on the right part of the
reel holder.
► Move this part of the reel holder evenly to the right by
approx. 2 mm.
► Screw both fixing screws back on tightly.
1
14 / 14 S
Figure 5.1 Configure reel holder
If 14 or 14 S-size wire-end ferrules are to be processed,
the respective reel holder must be brought back into the
original position.
32

5.2 Inserting wire-end ferrules

► Arrange the wire-end ferrule reels as specified on the
transport unit.
► Attach the wire-end ferrule reels (1) so that the ferrule
belts are routed into the transport unit from underneath.
Figure 5.2 Inserting wire-end ferrule roles
► Place the fixing pin with the small diameter into the bot-
tom opening of the transport unit.
You can find the fixing pin in the interior of the machine
(see Figure 3.3, 6).
Figure 5.3 Fixing the wire-end ferrule belt
► Guide the wire-end ferrule belt into the transport unit,
until the first ferrule latches in.
► Check for firm fitting by pulling the wire-end ferrule belt
carefully.
16 / 16 S
► Roll up the loose wire-end ferrule belt.
► Remove the fixing pin.
1
2583060000/00/03.2018