Led Indicator - Makita BFT020F Manual De Instrucciones

Reversing switch action
A 1
CAUTION:
• Always check the direction of rotation before opera-
tion.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
• When not operating the tool, always set the revers-
ing switch lever to the neutral position.
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for counter-
clockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
Lighting up the lamps
1
Function
Auto-stop fastening
Delayed re-start
004246
1. Reversing
switch lever
B
004247
1. Front lamp
Status
This function works when
the tool has reached the
preset fastening torque
and normal tightening has
been completed. This
helps overtightening to be
avoided.
For approximately one
second after auto-stop fas-
tening, the tool does not
start even if the switch trig-
ger is pulled.
CAUTION:
• Do not look in the light or see the source of light
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.

LED indicator

The lamp on the tool shows the following functions.
Status of the LED indicator/beeper
LED indicator
Lights up in green
for approximately
one second.
6
004338
1. LED indicator
1
Action to be taken
Beeper
-
003814
-