Schneider Airsystems PNG-PN 25 Manual De Instrucciones página 29

Problem
C Staples / Nails are
not fully inserted,
bend or protrude
D Tool repeatedly
misfires
E Staples /
jammed in
guide plate
F No staples / nails
are transported
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
Cause
Tappet worn or broken
Working pressure (flow pres-
sure) too low
Compressor output too small
Hose diameter too small
Piston sluggish because lubri-
cation insufficient
Working pressure (flow pres-
sure) too low
O-ring damaged
Hose diameter too small
Insertion depth setting incor-
rect (if available)
Nails Magazine (item 04) dirty
the
Staple / Nail strip jammed and/
or not pushed all the way for-
wards
Tappet worn
Staple/Nail jammed
No staples / nails in the maga-
zine
Tappet does not retract
Staple / Nail slider faulty
Magazine spring faulty
KLG / KNG / SNG /PNG
Remedy
Contact Schneider
GmbH or an authorised service
****
partner.
Increase working pressure (flow
pressure) Observe
*
working pressure
Use different output
*
rating
Use correct hose diameter
Lubricate device well via plug
***
nipple (item 01)
Increase working pressure (flow
pressure) Observe
*
working pressure
Contact Schneider
GmbH or an authorised service
****
partner.
Use correct hose diameter
Check and adjust insertion depth
setting.
Clean magazine
****
(blow out)
Incorrect staples / nails used. In-
sert the correct staples / nails
Contact Schneider
GmbH or an authorised service
****
partner.
Unlock the quick-release cover
(item 12) (if available) via the
magazine and remove the staple
or nail.
Insert the correct
****
nails
Increase working pressure (flow
pressure) Observe
*
working pressure
or contact Schneider Druckluft
GmbH or an authorised service
****
partner.
Contact Schneider
GmbH or an authorised service
****
partner.
Change magazine spring or
Contact Schneider
GmbH or an authorised service
****
partner.
GB
Druckluft
maximum
*
maximum
Druckluft
*
*
Druckluft
staples /
maximum
Druckluft
Druckluft
II/ 11