Section 6. Light Cartridge Replacement - Jandy Pro Serie Manual Del Propietário

Nicheless Underwater LED Lights | Owner's Manual
Section 6.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION,
which could result in serious injury or death.
Series Nicheless LED Lights are only available for 12-volt AC power.
For supply connection, use only an isolating low voltage power
supply with ungrounded output, evaluated and listed by a NRTL for
swimming pool use.
Always disconnect the power to the light at the circuit breaker before
installing or servicing the light. Failure to do so could result in death
or serious injury to serviceman, pool or spa users or others due to
electrical shock.
1. Verify that the light has been disconnected from the power source and
be sure that the light fixture is in a dry environment. Remove the eight
(8) screws from the lens with the tool provided. Pull the lens from the
fixture body. Remove and discard the O-ring between the Lens and
Fixture Body.
2. Using the tool provided, insert and turn the threaded portion into the
extraction hole in the face of the light cartridge. Pull the light cartridge
from the housing body.
3. Insert the replacement cartridge into the housing body. Line up the TAB
at the end of the circuit board with the receiving slot inside the housing
body. It may be necessary to slowly turn the light cartridge until the TAB
lines up with the slot.
Light Cartridge Replacement
WARNING
ENGLISH
The Jandy
®
Page 13
Pro