Restore Factory Settings - 1byone 716NA-0001 Manual De Instrucciones

will be played for every pulse beat during
EN
pulse rate measurement. When Beep is
DE
set to "off," no sound will be played
FR
during pulse rate measurement.
ES
IT
Note: If both Alarm and Beep are set to
"on," only the beep sound of the pulse
beats will be played. To make the alarm
sound work properly. Beep must be set
to "off."

Restore Factory Settings

In the Alarm Settings page, short press
the Power-On/Function button to move
"*" to Restore, then long press the button
to restore factory settings. This setting
will then read "OK."
Brightness Settings
In the Alarm Settings page, short press
the Power-On/Function button to
move "*" to Brightness, then long press
the button to change between five
11
brightness settings, with 1 being the
darkest and 5 being the brightest
setting.
Alarm Range Settings
In the Sound Settings page, you can set
the upper and lower limits of the SpO2
Alarm and PR (Pulse Rate) Alarm. First,
short press the Power-On/Function
button to move "*" down to the +/-
option so you can switch between
increasing (+) or decreasing (-) the
limits. Next, move "*" to each limit and
increase or decrease the limit by long
pressing the Power-On/Function
button. Move "*" to the Exit option and
long press to return to the monitoring
interface.
Operation Guide
Switching on the Pulse Oximeter
Place a finger on the rubber pad inside
the Oximeter. The pad of your finger
should rest over the sensor and your
12
EN
DE
FR
ES
IT