Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. After about one second "MEASURING" appears on the display indicating that the
instrument is ready to execute the first measurement.
7. Press the
FUNC key, the "MEASURING" symbol will disappear.
8. Disconnect the test lead. The symbol "
instrument is now ready to perform the second measurement.
9. Connect the test lead to the second L1 cable (see Fig. 14 2
nd
2
measurement).
10. When an input voltage greater than 80V is detected the buzzer sounds and the
PH
symbols "
" is shown on the main display. Don't press any key and keep the test
lead connected to L2 phase cable.
If the input voltage value is less to 80V instrument doesn't show "
symbol and its not possible to execute the phase rotation detection.
11. After about one second "MEASURING" appears indicating the instrument is ready to
execute the second measurement.
12. Press the
FUNC key, the "MEASURING" symbol disappears.
If you Wait more than 10 seconds between the first
the second, the instrument will display the "
necessary to repeat all the measurements from the beginning. Rotate the
selector to any position to escape the function and restart at step 1.
13. If the two test cables belong to the same phase, the instrument displays "
otherwise it shows "
different phases.
•
The detected voltage is NOT the phase to neutral voltage, but the
voltage between the conductor and the operator who is holding the
instrument. This value can be lower than the phase to neutral voltage.
DON'T TOUCH THE PHASE CABLE IF YOU AREN'T SURE THAT
ANY VOLTAGE IS PRESENT.
•
If the operator is insulated from the ground (e.g. insulated floors, shoes
with rubber souls, etc.) the instrument may not measure correctly. We
recommend repeating the test at least twice to assure the accuracy of
the obtained result.
2.1.3
1.2.3
." or "
." This indicates that the two cables belong to two
EN - 20
2
" appears on the secondary display. The
PH
WARNING
WARNING
SEC
WARNING
ACD-55HPQ
nd
measurement or Fig. 15,
FUNC key press and
" message and it's
PH
"
1.1.-.
",
Capítulos
Tabla de contenido
