Siggen - Signal Generator; Siggenen - Signal Generator Enable; Siggensweep - Signal Generator Sweep - ClearOne CONVERGE PRO 880 Manual De Instalación Y Funcionamiento

siGGen – Signal Generator
This command selects/reports of the signal generator activation.
Command Form: DEVICE siGGen [Channel Group Type Amplitude Frequency]
argument Type
Channel Channel
Group Group
Type unsigned integer
Amplitude Signed Float
Frequency unsigned Float
siGGenen – Signal Generator Enable
This command selects/reports of the signal generator activation.
Command Form: DEVICE siGGenen [Value]
argument Type
Value unsigned integer
siGGensWeep – Signal Generator Sweep
This command starts the signal generator with a tone and does a sweep. if Repeat is 0, the signal generator will
turn off after the sweep. if Repeat is 1, the signal generator will turn off after signal generator timeout. To stop
the sweep, send a SiGGenen command with a 0. during the sweep, the box will send out updated SiGGen
commands.
Command Form:
DEVICE siGGensWeep <Channel> <Group> <Amplitude> <Start Frequency> <end Frequency>
<increment Frequency> <rate> <repeat>
argument Type
Channel Channel
Group Group
Amplitude Signed Float
Start unsigned Float
Frequency
end unsigned Float
Frequency
increment unsigned Float
Frequency
rate unsigned integer
repeat unsigned integer
size values
1 See Groups and channels
(null to query in text)
1 1, 3, 7 (i, m, l)
2 1 = pink noise
2 = White noise
3 = Tone
4 -60.00 – 20.00
4 Type 1 – 2 0 (null in text)
Type 3 20.00 – 20000.00
size values
4 0 = off
1 = on
2 = Toggle
(null to query in text)
size values
1 See Groups and channels
1 1, 3, 7 (i, m, l)
2 -60.00 – 20.00
4 20.00 – 20000.00
4 20.00 – 20000.00 (must be greater than the
start)
4 1.00 – 20000.00
2 10 – 2000 ms
2 0 = repeat off
1 = repeat on
Units
dB
Hz
Units
Units
dB
Hz
Hz
Hz
Hz
Appendix A: Serial Commands 239