Assembly And Starting - SIP 06224 Manual De Instrucciones

The machine is to be used only for its prescribed pur
G
The user / operator and not the manufacturer will be
B
liable for any damage or injuries of any kind caused as
3.1 Work area
After unpacking and preparing the work area, posi
space around the compressor for maintenance activi
4. POINTS TO NOTE WHEN SETTING
UP THE COMPRESSOR
Report any damage immediately to the company
It is prohibited to use the compressor in areas where
A knife-switch MUST be installed up-line of
the machine with an automatic cut-out device
(safety circuit breaker) against over-currents,
fitted with a differential device calibrated at 30
mA (reference C in fig. 13).

5. ASSEMBLY AND STARTING

5.1 Assembling the wheels
If envisaged, the wheels must be mounted as shown in
figures 14a-14b and 15a-15b
5.2 Assembling the supporting feet
If envisaged, antivibration bushings must be mounted
as show in figure
5.3 Assembling the quick coupling
ref. E
ref. D
justed pressure to the coupling on the rear outlet as
shown in
5.4 Assembling the tap ball valve
in
5.5 Assembling the transport handle
the compressor, as shown in
5.6 Positioning the compressor
In versions with reservoir, do not fasten the
machine to the floor using shims so as not to
prevent normal vibration of the compressor.
Position the compressor at least 60 cm from the wall in
order to permit optimal recirculation of fresh air and to
safety distance of at least 6 meters between the com
Check for correspondence between the compressor
plate data with the actual specifications of the electrical
Single-phase 2 - 3 HP: fit the power supply cable plug
into a suitable socket, making sure that the red «OFF»
switch, on the machine's control panel, has been
fig. 22
Three-phase from 2 to 10 HP: connect the cables to a
the motor and that this matches the arrow on the mo
Warning: Three-phase
installed and connected by qualified personnel.
For the 5.5 S/D - 7.5 S/D - 10 HP models: check
that the pressure switch inside the electrical
cabinet is in the ON «I» position.
5.8 Checking the oil level
20
ref. F
versions must be